PIC16F1827 Touch Desk Lamp

This is the touch library of PIC. After installation, you will get a series of touch MCU demos. Find the library we want (including PIC16F1827), then copy it out, configure and modify it. Configure-->Select Device selects PIC16F1827. The default speed of the whole program is the on-chip crystal oscillator 16M.

①Configure generic_processorConfigBits.h to use the internal crystal oscillator, etc.

 There are two places that need to be modified: mTouch_config.h:

②This is the modification channel. 

 ③Modify the touch sensitivity. The smaller the value, the greater the sensitivity.

 ④ Read the touch value in the main function main.c. The CAP_DATA value here is probably 1 or 2.

 Using PIC's touch library for touch processing, the effect is very good.

Things you need:

1. Electronic materials: MCU: 51 core (AT89CXX, STC89CXX), AVR (ATMEGE8, ATMEGE16, ATMEG48), PIC (PIC16F877, PIC16F1827), ARM (STM32, S3C2440), GASIA (GA452P16, GA452P26); resistor (0.01Ω-100MΩ), capacitor (5PF-0.1F), Diodes (IN4001-4007, SS14, 5819), transistors (8050, 8550, 9013, 9014, 3904,), MOS tubes (2301, 2302, 7002, 5802, TIP122), relays (single-pole relays, double-pole relays, single-pole double-throw, single-pole triple-throw), operational amplifiers (258, 358, 324, 339, OP07, 386, TDA2030), EEPROM (24 C01, 24C02-24C516), digital IC (4017, 4011, 40110, 555, 7555, 4511, 595,), voltage regulator (317, 7805, 7809, 78L05, 7555, 1117, 1.8V-36V voltage regulator), buzzer (buzzer, buzzer), sensor (ultrasonic transceiver, infrared receiver 1838, photodiode, phototransistor, pyroelectric, thermistor PT100, Thermistor PT1K, thermocouple CU50, temperature 18B20, temperature LM35), clock (DS1302, DS1887, PCF8563), wired (high voltage 485), wireless (433 module, RC500, 2.4G), LCD driver HT1621B, touch IC, font IC, LCD (segment LCD, 1602, 12864, TFT), dot matrix (8*8, 16*16, two-color dot matrix, three-color dot matrix RGB).