Keithley DMM7510 7.5-digit desktop multimeter is said to be comparable to 8.5-digit multimeters on the market in terms of performance and functions. In early September, an old customer in Shenzhen sent a faulty machine to the repair company, reporting that the instrument could not be turned on. The following is a simple repair measure shared by an Antai Keithley maintenance engineer:
Fault phenomenon
The instrument cannot be turned on normally after powering on.
Inspection and repair
The instrument cannot be turned on. First, solve the problem of turning on. After a series of inspections, it was found that the logic unit of the instrument control board was damaged. After replacing the damaged components, the instrument can be turned on normally, but a new fault occurred. The error A/D time out appeared when it was turned on. Continue to check and detect, and find that the instrument mainboard is faulty, causing the instrument to report an error. Replace the damaged components and test the instrument.
Repair results
The instrument starts normally, the error disappears, the measurement signal is normal, and the repair is completed.
Previous article:What is an SMU source meter? What are its functions and advantages?
Next article:How to determine the electrodes of thyristors
- Popular Resources
- Popular amplifiers
- From probes to power supplies, Tektronix is leading the way in comprehensive innovation in power electronics testing
- Seizing the Opportunities in the Chinese Application Market: NI's Challenges and Answers
- Tektronix Launches Breakthrough Power Measurement Tools to Accelerate Innovation as Global Electrification Accelerates
- Not all oscilloscopes are created equal: Why ADCs and low noise floor matter
- Enable TekHSI high-speed interface function to accelerate the remote transmission of waveform data
- How to measure the quality of soft start thyristor
- How to use a multimeter to judge whether a soft starter is good or bad
- What are the advantages and disadvantages of non-contact temperature sensors?
- In what situations are non-contact temperature sensors widely used?
- LED chemical incompatibility test to see which chemicals LEDs can be used with
- Application of ARM9 hardware coprocessor on WinCE embedded motherboard
- What are the key points for selecting rotor flowmeter?
- LM317 high power charger circuit
- A brief analysis of Embest's application and development of embedded medical devices
- Single-phase RC protection circuit
- stm32 PVD programmable voltage monitor
- Introduction and measurement of edge trigger and level trigger of 51 single chip microcomputer
- Improved design of Linux system software shell protection technology
- What to do if the ABB robot protection device stops
- Huawei's Strategic Department Director Gai Gang: The cumulative installed base of open source Euler operating system exceeds 10 million sets
- Download from the Internet--ARM Getting Started Notes
- Learn ARM development(22)
- Learn ARM development(21)
- Learn ARM development(20)
- Learn ARM development(19)
- Learn ARM development(14)
- Learn ARM development(15)
- Analysis of the application of several common contact parts in high-voltage connectors of new energy vehicles
- Wiring harness durability test and contact voltage drop test method
- Problems and Solutions in TMS320F206 Simulation Debugging
- Disassembly of 10 yuan smart bracelet
- Last day! Microchip Live Broadcast | How to solve precision timing challenges in ADAS systems
- [Fudan Micro FM33LG0 Series Development Board Review] Basic Introduction
- MaxplusII advanced use and improvement.rar
- Talking about software architecture from the perspective of history - object-oriented programming (Part 3)
- DCDC input end inrush current problem
- Non-blocking assignment order problem
- [Raspberry Pi 4B Review] + Real-time status monitoring website server construction
- Smart Home Series Articles | Battle for Control: Who is the control center of the smart home system?