[b][color=#5E7384]This content is originally created by EEWORLD forum user [size=3]tiankai001[/size]. If you need to reprint or use it for commercial purposes, you must obtain the author's consent and
[i=s]This post was last edited by jinglixixi on 2020-11-1 00:14[/i]1. Use GPIO port to simulate I2C interface
An LED flashing program is provided in the example. Through it, we can master the method o
Recently, Pmos is used as a ms-level switch circuit. IRF5305s is selected, and the circuit schematic is shown in Figure 1. The signal is the MCU signal 3.3v, and the power supply is 12v. The MCU contr
I need help with the component library, because I am used to building the circuit in multisim... After building it, I found that I couldn't find the components and couldn't make the board
As shown in the figure below: ZJ8V voltage is 8V, VSTAND voltage should be 5V, but the actual voltage is 2.96V. When R113 is removed and R112 is short-circuited, the voltage is 2.5V, which is normal.