Features .......................................................................................................................................................................................1
Ordering Information .....................................................................................................................................................................2
Dimensions and Patterns ― 3.2 x 2.5 mm .................................................................................................................................14
Dimensions and Patterns ― 5.0 x 3.2 mm .................................................................................................................................14
Dimensions and Patterns ― 7.0 x 5.0 mm .................................................................................................................................15
Additional Information .................................................................................................................................................................16
Revision History ..........................................................................................................................................................................17
Rev 1.07
Page 3 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Electrical Characteristics
Table 2. Electrical Characteristics – Common to LVPECL, LVDS and HCSL
All Min and Max limits in the Electrical Characteristics tables are specified over temperature and rated operating voltage with standard
output termination shown in the termination diagrams. Typical values are at 25°C and nominal supply voltage.
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
Min.
220.000001
-15
-25
-35
-50
Operating Temperature Range
T_use
-20
-40
-40
-40
Supply Voltage
Vdd
2.97
2.70
2.52
2.25
Pull Range
Upper Control Voltage
Lower Control Voltage
Control Voltage Input Impedance
Control Voltage Input Bandwidth
Pull Range Linearity
Frequency Change Polarity
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Start-up Time
OE Enable/Disable Time
PR
VC_U
VC_L
VC_z
V_c
Lin
–
VIH
VIL
Z_in
DC
T_start
T_oe
70%
–
–
45
–
–
Typ.
–
–
–
–
–
–
–
–
–
3.30
3.00
2.80
2.50
Max.
725
+15
+25
+35
+50
+70
+85
+95
+105
Supply Voltage
3.63
3.30
3.08
2.75
V
V
V
V
ppm
Vdd
Vdd
MΩ
kHz
%
–
–
30%
-
55
3.0
3.8
Vdd
Vdd
kΩ
%
ms
µs
Measured from the time Vdd reaches its rated minimum value.
f = 322.265625 MHz. Measured from the time OE pin reaches
rated VIH and VIL to the time clock pins reach 90% of swing
and high-Z. See
Figure 9
and
Figure 10
Pin 2, OE
Pin 2, OE
Pin 2, OE logic high or logic low
Contact SiTime
for other input bandwidth options
See the APR (Absolute Pull Range)
Table 11.
Contact SiTime
for custom pull range options
Voltage at which maximum frequency deviation is guaranteed
Voltage at which minimum frequency deviation is guaranteed
Unit
MHz
ppm
ppm
ppm
ppm
°C
°C
°C
°C
Extended Industrial
Extended Commercial
Industrial
Condition
Accurate to 6 decimal places
Inclusive of initial tolerance, operating temperature, rated
power supply voltage, load variations, and first year aging
at 25°C, with VIN voltage at Vdd/2.
±15
ppm is only guaranteed for pull range up to
±100
ppm.
Frequency Range
Frequency Stability
Temperature Range
Voltage Control Characteristics
±25, ±50, ±80, ±100, ±150, ±200,
±400, ±800, ±1600, ±3200
90%
–
–
–
–
–
–
10
10
–
Positive Slope
–
–
100
–
–
–
–
10%
–
–
1.0
Input Characteristics
Output Characteristics
Startup and OE Timing
Rev 1.07
Page 4 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Table 3. Electrical Characteristics – LVPECL Specific
Parameter
Current Consumption
OE Disable Supply Current
Output Disable Leakage Current
Maximum Output Current
Output High Voltage
Output Low Voltage
Output Differential Voltage Swing
Rise/Fall Time
RMS Period Jitter
[4]
RMS Phase Jitter (random)
Symbol
Idd
I_OE
I_leak
I_driver
VOH
VOL
V_Swing
Tr, Tf
T_jitt
T_phj
–
0.220
0.270
ps
Min.
–
–
–
–
Vdd-1.15
Vdd-1.9
1.2
–
–
Typ.
–
–
0.15
–
–
–
1.6
225
1.0
Max.
97
63
–
32
Vdd-0.7
Vdd-1.5
2.0
290
1.6
Unit
mA
mA
A
mA
V
V
V
ps
ps
Condition
Excluding Load Termination Current, Vdd = 3.3 V or 2.5 V
OE = Low
OE = Low
Maximum average current drawn from OUT+ or OUT-
See
Figure 5
See
Figure 5
See
Figure 6
20% to 80%, see
Figure 6
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 156.25 or 322.265625 MHz, IEEE802.3-2005 10 GbE jitter
mask integration bandwidth = 1.875 MHz to 20 MHz,
all Vdd levels
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 322.265625 MHz, IEEE802.3-2005 10 GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, all Vdd levels
The packaging and testing market will reach US$25.5 billion in 2008(China Electronics News)Zhou Yanwu, Research Director of Shuiqingmuhua 2006-6-20 According to forecasts, the global IC packaging a...
I want to use MOS tube to drive a 12V/20A DC motor, PWM speed control, everything else is OK, but I don't know how to choose the freewheeling diode, please give me some advice...
[i=s]This post was last edited by shijizai on 2018-12-14 15:13[/i] Is there any rule for setting the serial port baud rate? Why are they 2400, 9600, 19200..., just like the baud rate required values i...
[i=s]This post was last edited by Yishayishi on 2022-8-4 15:21[/i]Company A produces gas meters. Company A has a unique technology in gas meters, but Company A has not applied for a patent. Company A ...
Multimedia processors are often
the most power-hungry devices in
portable
electronic
devices. The common approach to reducing CPU power requirements is to reduce the clock frequency or o...[Details]
Kyoto University in Japan recently announced that its researchers have built a space solar power generation experimental facility, which is mainly used to verify the feasibility of transmitting ene...[Details]
0 Introduction
Communication networks have been popularized in all aspects of human life. Network video acquisition systems with wide control areas are also developing rapidly. The server of the emb...[Details]
Since the emergence of external lighting, we divide lighting into three eras: the filament bulb era (incandescent lamp), the gas bulb era (fluorescent lamp), and the semiconductor light-emitting er...[Details]
I. Introduction
The logic analyzer is recognized as the most outstanding tool in the process of digital design verification and debugging. It can check whether the digital circuit is working properly...[Details]
On the evening of August 25, Meiya Pico released its 2021 semi-annual performance announcement, achieving revenue of 790 million yuan in the first half of the year, a year-on-year increase of 29.25%;...[Details]
OFweek Cup · OFweek 2023 China
Robot
Industry Annual Selection (abbreviated as OFweek Robot Awards 2023) is jointly organized by OFweek, China's high-tech industry portal, and its authorita...[Details]
Introduction In recent years, small mobile devices such as smartphones have added many functions in addition to telephone functions, such as digital cameras, games, web browsing, and music players, ...[Details]
According to foreign media Teslarati, Lucid has announced details of its advanced driver assistance system (ADAS) DreamDrive. The company calls it "the most technologically advanced advanced driver a...[Details]
On April 27, Beijing Junzheng released its first quarter report of 2022, stating that the company achieved operating income of 1.414 billion yuan in Q1, a year-on-year increase of 32.37%; net profit ...[Details]
The main function of a solar inverter is to convert the direct current generated by solar panels into alternating current that can be connected to the grid through a power module. The reliability a...[Details]
In the field of GaN LEDs such as
blue and white
LEDs
, Japanese manufacturers are still in an advantageous position. The reason is that they have the largest share of mass production in the worl...[Details]
Wenzhou, Zhejiang, November 3, 2024 /PRNewswire/ -- This fall, Ruipu Lanjun has innovated the full-scenario power solution for commercial vehicles and passenger vehicles! Whether you need ultra-low...[Details]