Photoelectric phase failure protection circuit
Source: InternetPublisher:spectrum Keywords: Protection circuit photoelectric type phase failure protection BSP Updated: 2020/02/20
It uses three light-emitting diodes VLi-VLs and three photoelectric tubes VTi-VT3 as
detection elements. Use a file to remove the tube caps of VTi~VT3 to expose the die silicon.
When one phase of the power supply is missing, one light-emitting diode does not light up, the transistor VT4 is cut off, and VTs is turned on, causing the relay
KA to close, the contactor to release, and the motor to stop.
Latest Control Circuits Circuits
- Controlling LEDs with Multithreading via Dual-Core Programming on Raspberry Pi using MicroPython
- How to Make a Simple Chicken Incubator
- Motor automatic cycle control circuit
- Hydraulic control circuit design and analysis
- Do-it-yourself trial production of phase failure protection device
- An experimental model of an infrared radio alarm
- Ultra-short wave item left behind reminder alarm
- Bicycle anti-theft alarm
- "Watchdog" anti-theft alarm circuit
- Simple disconnection burglar alarm
Popular Circuits
- Voice controlled flash LED light circuit diagram
- strain sensor
- Domestic KD8041 integrated phase locked loop
- Diode Balanced Mixer Circuit
- Double gate field effect transistor high frequency amplifier circuit
- Fault signal trip circuit
- Motorcycle flash light circuit
- Various signal generator circuits
- Home appliance repair signal generator circuit
- Sawtooth wave generator circuit (2)
京公网安备 11010802033920号