RC surge suppressor wiring
Source: InternetPublisher:sigma Keywords: Wiring surge suppressor RC BSP Updated: 2021/08/05
In order to suppress overvoltage caused by the vacuum circuit breaker switching high-voltage motors, RC surge suppressors , varistors
, zinc oxide arresters, etc. can be used.
The wiring is shown in Figure 4-60. Usually the capacitance C is 0.1~0.5yF and the resistance R is 100~200CZ. After installing the RC surge
suppressor, the overvoltage generated by the vacuum circuit breaker can be limited to about 2 times the rated voltage, which is relatively safe.
Latest Control Circuits Circuits
- Model rocket launch controller circuit
- Build a glove-controlled robotic arm
- How to make a wheeled self-balancing robot using ultrasonic sensors
- A small improvement to the temperature and water level indicator alarm
- Design and analysis of wire control circuit
- Design and analysis of a four-bit remote control component capable of remote reset
- Design and analysis of voice control circuit
- Simple three-phase motor phase loss protection circuit
- Magnetic door and window anti-theft alarm
- Ultra-short wave item left behind reminder alarm
Popular Circuits
- electromagnetic field sensor
- Self-defense anti-riot circuit
- Pulse therapy circuit
- AC voltmeter
- Domestic KD8041 integrated phase locked loop
- Inductive feedback oscillator circuit
- Voltage controlled power supply second-order high-pass filter circuit
- Power phase sequence display circuit
- Home appliance repair signal generator circuit
- Sine wave signal generator circuit
京公网安备 11010802033920号