Wiring a when the leakage protector supplies power to single-phase loads in the TN system
Source: InternetPublisher:MartinFowler Keywords: Wiring leakage protector power supply BSP Updated: 2020/06/01
Wiring a when the leakage protector supplies power to single-phase loads in the TN system
TN system, that is, the neutral point on the power side is directly grounded.
In the figure, the TN-C system is a three-phase four-wire system in which the working neutral line N and the protective neutral line PE are combined into a PEN line; the TN-S system neutral line N cannot be connected to the neutral of
other equipment or lines without leakage protectors. Line N is shared and is not allowed to
be connected to the protective neutral line PE, equipment metal shells, wire steel pipes and other metal parts connected to the earth. That is to say,
a system with three phase lines, a general neutral line N and a protective neutral line PE (PE is led separately from the neutral point of the transformer) through the leakage system
is also called a five-wire system.
- Step-down power supply for driving relays
- MT3608 constitutes a 3.7V to 12V boost circuit diagram
- Use pulse width modulation to get a precise output voltage
- The constant current source composed of two transistors can drive high power
- Detailed explanation of 5v charger circuit diagram
- Homemade low-power UPS
- 0.7~24V continuously adjustable current limiting power supply
- MAX1811 Lithium Battery Charger Production
- How to Select Modular EMI Filters for AC-DC Converters
- Make a simple electric car battery charger
- electromagnetic field sensor
- Agricultural small tractor lighting circuit
- Diode Balanced Mixer Circuit
- Series crystal oscillator
- Wireless microphone circuit
- superheterodyne radio circuit
- Three primary color display circuit
- Various signal generator circuits
- Sawtooth wave generator circuit (2)
- Sine wave signal generator circuit