Audio interface protection circuit
Source: InternetPublisher:偷熊计划 Keywords: Protection Circuit Updated: 2024/11/07
■G1 is a SMD triode ceramic tube LT-B3D230L, used as the front stage for common mode and differential mode protection.
■PTC1~PTC2 are used to isolate the front and rear stages of JK250-120U.
■T1~T3 are low voltage P4SMAJ6.5CA TVS tubes, used as post-stage protection.
■The protection capability of this solution is 5KV (10/7000μs).
■If there is no grounding, only differential mode protection is provided. G1 is LT-BC151N.
- How to Make a Simple 2-Step Arduino Programmable Timer Circuit
- Tutorial on making your own remote-controlled robotic arm
- Peripheral circuit of automotive motor controller power supply chip
- Replace the GE LOGIQ a200 ultrasound measurement key with a self-made touch switch
- DC motor drive circuit composed of L293D
- Electric vehicle battery charging protection circuit
- Precious home appliance anti-theft alarm
- Car audio system anti-theft circuit
- Bicycle anti-theft alarm
- Vibration anti-theft alarm circuit
- Resistive Neutral Leakage Protection Circuit
- High voltage automatic protection circuit
- Thyristor silicon stack protection circuitb
- Thyristor resistance-capacitance protection circuit b
- Three-phase motor protection circuit
- Thyristor overcurrent protection circuit 4
- Thyristor type overcurrent protection circuit 3
- Mains undervoltage and overvoltage protection circuit 4
- Mains overvoltage protection circuit
- Overcurrent protection circuit for generator low voltage starting a