A cheap and easy-to-make infrared TV signal repeater
Source: InternetPublisher:黄土马家 Keywords: Infrared transponder Updated: 2024/11/11
At present, the radio and television network has upgraded the original analog signal to a digital signal, which needs to be demodulated by a set-top box before it can be viewed. Since a set-top box can only connect to one TV, if there are two TVs in a home, two set-top boxes are needed. For those that are not used at the same time, infrared repeaters can be used to share them. For this purpose, through searching for information, making, improving, and using it, the working principle is briefly introduced, see the attached figure.
The components used in this circuit are all easy-to-purchase common components with strong anti-interference, low cost, easy to make, and can work normally without debugging.
The circuit is based on the commonly used time base circuit NE555. The infrared receiving head needs to use an integrated high level in static state and a low level when receiving the remote control signal, otherwise the circuit cannot work properly. The infrared emitting diode is a common infrared emitting tube, and other components can be as given in the figure. Its working principle is that the infrared integrated receiving head receives the infrared signal sent by the remote control to control the conduction and cutoff of the Q1 tube to achieve whether the IC is powered. Once the IC is powered, it will generate a 38kHz signal by itself, and output a high level through the ③ pin to turn on Q2, and the infrared emitting tube sends out an infrared signal.
It is connected by a universal board, and can be powered on for testing after checking the circuit diagram. After it is normal, place the receiving head in the room, extend the transmitting tube with a lead to the vicinity of the infrared receiving window of the receiver, and then the set-top box can be remotely controlled.
- Production of a FM wireless microphone
- Making an FM receiver with a high-frequency head
- Homemade FM wireless microphone for teaching
- 1W FM Broadcast Transmitter
- MICRF011 00K 440~300 MHz Receiver/Data Demodulator
- MICRFl04 ASK 470~300 MHz Transmitter
- RXM-900-HP-II FM/FSK 928~902 MHz Receiver Module
- nRF903 GMSK/GFSK 950~430 MHz transceiver
- T5761/T5760 ASK/FSK 870~868 MHz/928~902 MHz Receiver
- MCl3135/MCl3136 FM 200 MHz Double Conversion Narrowband FM Receiver
- Schematic diagram of infrared automatic door control system
- Infrared anti-theft alarm circuit 2
- MC145026 (cordless phone and half-duplex remote control) infrared, ultrasonic or radio frequency remote control encoding circuit
- MC145026 (general) infrared, ultrasonic or radio frequency remote control transmission encoding circuit
- Infrared reciprocating device circuit
- Infrared monitoring remote alarm circuit-c
- DSX-50A type infrared high temperature electronic disinfection cabinet circuit diagram
- Infrared blind cane circuit diagram
- Infrared controlled telephone password lock circuit
- Reflective infrared corridor lighting controller