Electrical schematic diagram of DC voltmeter input at non-inverting terminal
Source: InternetPublisher:风向双子座 Keywords: Voltmeter DC voltage BSP Updated: 2020/03/23
The non-inverting terminal inputs A, and the electrical schematic diagram of a DC voltmeter composed of a milliamp meter is shown in the figure.
In the figure, the operational amplifier uses LM324.
In order to reduce the impact of the meter parameters on the measurement accuracy, the meter is placed in
the feedback loop of the operational amplifier, and the range can be switched by simply changing a resistor
. After the resistance is determined, the ammeter can be calibrated directly with the voltage value.
It should be noted that the circuit in the figure is suitable for measuring
related circuits that share a common ground with the operational amplifier circuit. In addition, when the measured voltage is high,
an attenuator should be set at the input end of the op amp.
- How to Build a Simple FM Radio Receiver on a Breadboard
- Analysis of the reasons why bow-tie antennas are preferred over microstrip antennas for 5G antennas
- Homemade FM wireless microphone for teaching
- FM microphone made by 9018
- RF2942 I/Q 915 MHz Transmitter
- MAX2366/MAX2367/MAX2368 I/Q 2000-1700 MHz/1000-800 MHz dual-band
- R5 433.92 MHz Receiver Module
- Eight-way remote control transmitter circuit using CS901
- Cordless phone transmitter circuit
- rfPICl2C509AG/509AF ASK/FSK 480~310 MHz with 8-bit microcontroller transmitter
- Set timing circuit when power is on
- Crop anti-frost circuit
- Particle clogging alarm circuit of wheat seeder
- Farmland drainage automatic control circuit
- Proportional frequency discriminator circuit
- ring amplitude modulation circuit
- Voltage series negative feedback amplifier circuit
- Voltage controlled power supply second-order high-pass filter circuit
- superheterodyne radio circuit
- Power phase sequence display circuit