A connection circuit using only 5V power supply
Source: InternetPublisher:黄土马家 Keywords: Power supply BSP operational amplifier Updated: 2021/01/08
It is converted into a pulse width modulation (PWM) signal by the error processing link and output from pin 3 (MC
signal). At the same time, the differential of the position error is also calculated, which represents the movement speed of D and
is selected from pins 6 and 7 for system damping. One of them is proportional to positive speed and the other
is proportional to negative speed. Both signals are converted into analog damping signals in an external op amp
. Another operational amplifier can be used to synthesize the position error and damping signal into an
analog signal, which is used to control the subsequent power amplifier and drive the DC motor. (See Figure
13-17). The gain and damping of the system can be adjusted by the two resistors RD and R. to
optimize the performance of the system.
- Current output characteristics of brushed motor driver chips. How to increase the peak drive current?
- Car ice warning circuit sharing
- How to Build a Touch-Based Color-Changing Plant Using Arduino
- How to Build a Gesture-Controlled Elevator Prototype Using Arduino Nano
- DIY an electromagnetic levitation device
- Manual automatic air compressor control circuit
- Motor control circuit for starting and running without phase loss
- Starting method of asynchronous motor with external frequency-sensitive resistor
- Add one more component to improve the phase failure protection function
- Home wireless burglar alarm circuit
- Voice controlled flash LED light circuit diagram
- Ultrasonic blind pathfinder circuit
- Inpatient pager circuit
- Physiotherapy ventilator circuit
- Egg warming circuit
- Crop anti-frost circuit
- Amplitude modulation circuit composed of MC1496
- Crabo oscillator circuit
- High and low frequency signal generator circuit
- Three primary color display circuit