Common emitter-common emitter amplifier
Source: InternetPublisher:酷到被通缉 Keywords: Amplifier BSP input resistor Updated: 2020/04/21
It is currently the most commonly used circuit
configuration, as shown in Figure 8-3. It is
composed of two common-emitter circuit couplings with the same characteristics . The coupling form can be resistance-capacitance coupling or direct coupling. Since the input resistance of this circuit is much smaller than the output resistance, the voltage gain of the preamplifier will be reduced by the input resistance
of the subsequent amplifier . Even so, the overall gain obtained
with this configuration of circuit is still the maximum. The total gain of a
multi-stage amplifier is the product of the gains of each stage (if expressed in decibels, it is the sum of decibels).
- LED lights that “drain” battery power
- Common electrical circuits: frequency-selective (bandpass) amplifier circuit
- Homemade air conditioner outdoor unit shutdown indicator
- Frequency divider that converts 50Hz or 60Hz frequency into 1/60 frequency (CD4040)
- Phase-locked Frequency Multiplier(9316)
- Digital frequency multiplier (LM108, LM111)
- Design circuit of voltage inverter using PWM
- Power-saving LED dimming circuit
- Broadband transconductance operational amplifier and buffer OPA660 common collector (common-C) amplifier circuit
- Low noise preamplifier circuit composed of OPA37
- Set timing circuit when power is on
- electromagnetic field sensor
- Voice controlled flash LED light circuit diagram
- Excellent performance household inverter power supply circuit
- Electronic thermometer circuit
- Particle clogging alarm circuit of wheat seeder
- Farmland irrigation automatic control circuit a
- AC voltmeter
- OTL low frequency power amplifier circuit
- Fault signal trip circuit
京公网安备 11010802033920号