There is an allgro17.2 BRD file that needs to be converted to PCB format below PAD9.5

lhz315

There is an allgro17.2 BRD file that needs to be converted to PCB format below PAD9.5 [Copy link]

Is there any kind-hearted person passing by who can help me?

I found gerber again and put it up there too.

lhz315

Can anyone help?

qwqwqw2088

Don't worry, I will reply if the transfer is successful.

I didn't succeed here.

lhz315

qwqwqw2088 posted on 2022-5-5 11:33 Don't worry, those who have successfully transferred will reply. I didn't transfer successfully here

What did you use to turn it?

qwqwqw2088

lhz315 posted on 2022-5-5 11:42 What did you use to transfer it?

The computer must have Cadence

The software version must also match the BRD file to be converted

lhz315

It seems that no one can turn...

se7ens

Why transfer?

These files can be used to produce PCB

lhz315

This is a development board, and I need to modify it and delete some ports. I don't have this software either.

I want to keep the DDR wiring and BGA wiring above, it is very troublesome to re-route

lhz315

The gerber has been transferred to pads, and the components need to be rearranged

okhxyyo

I haven't installed the software. If you have AD, you can first go to AD to open it, and then convert it to PADS

emt119p

Pls pass schmematic ? Thank