Newbie help, ESP8266 program problem

转转丶

Newbie help, ESP8266 program problem [Copy link]

 

When the board is connected to uPyCraft_V1.1,

Download the program and run it normally.

After disconnecting, resetting and restarting, the program does not run normally.

Every time you need to open the software, re-download and run it normally.

How to solve it? How to run normally with a single power supply?

The code has been uploaded, which is the program for displaying temperature and humidity at 0.96 OLED.

dcexpert

Is the code saved as main.py?

转转丶

dcexpert posted on 2022-3-29 20:57 Is the code saved as main.py?

Yes

dcexpert

If you are not sure about the specific situation, you can mainly look for problems from the following aspects:

1. If you change to other software, such as thonny and upycraft, there are quite a lot of bugs.
2. Make sure all relevant libraries are copied to the board.
3. Some boards use DTR to control whether to run or download firmware after power-on, which may cause problems.

lugl4313820

You'd better print it to see where the program went so that you can troubleshoot the problem.

Fred_1977

Which chip is ESP8266?

dcexpert

Fred_1977 posted on 2022-3-30 08:54 Which chip is ESP8266!

Espressif's