What parameters need to be provided to manufacturers in the design of high-frequency transformers?

QWE4562009

What parameters need to be provided to manufacturers in the design of high-frequency transformers? [Copy link]

What parameters should be provided to the manufacturer for the design of high-frequency transformers?

1. Leakage inductance ------ The leakage inductance of the primary winding can be obtained through testing. The common method is to short-circuit each secondary winding to test

the inductance of the primary winding at this time. This value is the leakage inductance of the primary winding.

2. Inductance ------ The secondary is open-circuited to measure the primary inductance. The instrument is set to LCR 1KHZ test.

3. Primary winding input voltage, primary winding output current, control signal frequency, power

4. Secondary winding output voltage, load current, load signal frequency, power -- voltage can calculate the number of turns ratio

5. Primary winding wire diameter, wire length, impedance

6. Secondary winding wire diameter, wire length, impedance

7. Skeleton type, core type

annysky2012

I thought you were going to answer the question, but it turned out to be sharing the answer. Thank you.

QWE4562009

annysky2012 posted on 2022-1-19 11:47 I thought you were going to answer the question, but it turned out to be sharing the answer. Thank you, thank you

I want to ask a question, bro

QWE4562009

How to design a high frequency transformer?