[Gizwits Gokit3 Review] Part 1: Some problems encountered during unboxing test

w494143467

[Gizwits Gokit3 Review] Part 1: Some problems encountered during unboxing test [Copy link]

 

1. Introduction

My application was not approved the first time, but I was quite excited when it was approved the second time. I wanted to test it immediately after getting the board, but the QR code on the instruction manual had expired, so I went to the official website to download the software. Let’s take a look at the unboxing first.

2. Unboxing

It was well protected when I received it, and was packaged in an acrylic box. My board is an Arduino board. Although I have little contact with Arduino, it is still easy to use. Let's take a look at the overall appearance first.

Figure 1

Figure 2

Then power on and test it. After powering on, several LED lights are on, and the Wifi module is also flashing normally.

Figure 3

Then check the official instructions, press and hold Key2 to enter the configuration state, and the green light will turn on after long pressing.

Figure 4

I thought there should be a program when it leaves the factory, so I directly opened the downloaded test APP and performed the following steps.

Figure 5

Figure 6

Figure 7

Figure 8

I thought it would work normally until Figure 8, but it seems that it cannot be used normally. I began to doubt whether it was not included with the factory program. But I thought it shouldn’t be the case. Then I checked other people’s posts and found that everyone generated and configured the program by themselves. Here I want to ask, is it really true that it is not included with the factory program?

littleshrimp

Do you need to connect to the corresponding AP in your mobile phone WLAN?

http://docs.gizwits.com/zh-cn/deviceDev/WiFiSOC/GoKit3S%E4%BD%BF%E7%94%A8%E8%AF%B4%E6%98%8E%E4%B9%A6. html

Jacktang

There is no factory program with test, so you can't just transplant the program and play with it.

Is there a setting problem somewhere?

青春最好时

It doesn't work when I turn on the power, and then I configure the program myself, it should be factory-installed

w494143467

Jacktang posted on 2021-3-6 08:24 Is there no factory program with test? You can't just let everyone transplant the program to play with it. Is there a setting problem somewhere?

Judging from this phenomenon, it seems that there is no belt.

w494143467

The best time of youth was published on 2021-3-6 09:41 It didn't work when I powered it on, and then I configured the program myself. It should not have been programmed when it left the factory

Then I'll configure it myself!

annysky2012

The board I sent you does not have a program. If you want to write your own program, you can test it according to my review.

w494143467

annysky2012 posted on 2021-3-6 13:52 The board sent here does not have a program. If you want to write a program yourself, you can test it according to my review

Okay, I'll try it when I have time!