AD9 usage issues

呜呼哀哉

AD9 usage issues [Copy link]

Universal forum friend:

1. Have you ever seen that during the use of AD9, some device pins in the schematic diagram occasionally appear to be floating when not in use, and when updating the PCB, it reports "failed to add net class"?

2. Have you ever seen the parameters of components in the schematic diagram written in the commet, and then manually changed and updated the PCB, 10nF--→1nF, and the update report status is a red X, with no explanation

These two problems occur occasionally. The same installation package works fine at work, but the above problems occur at home.

btty038

Why don't you upgrade to the current version?

btty038

Sometimes the crack is caused by the computer software settings. AD also has bugs.

okhxyyo

The cracked version has the property of occasional convulsions. I have encountered both of the problems you mentioned. Manual adjustment or re-importing may solve the problem.

okhxyyo

For the pin that is floating, you can check whether it is a problem with the properties you set. If there is no problem, it may be that the AD is defective.

呜呼哀哉

okhxyyo posted on 2021-1-28 16:03 You can check if the pin is floating and whether it is a problem with the properties you set. If there is no problem, it may be that the AD is pulled.

Where can I check the properties of this setting? I want to add a net to the empty pins, for example, NC1 and NC2 are arranged down when they are not used, which is quite troublesome

呜呼哀哉

okhxyyo posted on 2021-1-28 16:03 You can check if the pin is floating and whether it is a problem with the properties you set. If there is no problem, it may be that the AD is pulled.

Is it the schematic interface, project, the second item in the bottom menu, the mosaic setting? I checked it and there is no problem.