The board does not run the program after burning

chenbingjy

The board does not run the program after burning [Copy link]

The board made by the company does not run the program after burning, and needs simulation to run.

In fact, it was running after burning, but I reinstalled the system a few days ago and accidentally deleted the hard drive.

It was not installed properly, and I couldn't figure out which drive was which. The C drive became the D drive, and the D drive became the C drive.

I recovered part of it, but the WIN7 I installed couldn’t access the Internet. I don’t know what happened.

I installed WIN10 again, forgot to back up the files I had recovered, and deleted them again. Now I can't find them back at all.

Fortunately, it was saved in the network disk. As a result, the program was like this, and it could not be run after burning.

The board hardware and software have not changed. Very strange.

Does anyone know what could be going on? Thanks!

wsmysyn

Try with another computer?

chunyang

The software has not been changed, so this may not be the case. Unless the network disk is operated manually, there may be a time cycle for automatic operation, and it may not be the latest version.

chenbingjy

chunyang posted on 2020-6-19 12:08 The software has not been moved, I am afraid this is not necessarily the case. Unless the network disk is operated manually, if it is operated automatically, there may be a time cycle, and it may not be the latest version.

Manual operation

chunyang

chenbingjy posted on 2020-6-19 13:40 Manual operation

If you are doing it manually, you need to think carefully about any negligence during the process and how you solved the previous problems.

chenbingjy

wsmysyn posted on 2020-6-19 09:49 Try using another computer?

I changed the computer and it was fine. How strange. It may be related to the computer.

wsmysyn

chenbingjy posted on 2020-6-22 08:53 I changed the computer and it was fine. So strange. It has something to do with the computer.