3279 views|3 replies

1

Posts

0

Resources
The OP
 

About the disassembly and welding of this type of module [Copy link]

Front and back of module Front and back of soldering pad When disassembling the module, it is easy to blow off the module cover if the air gun cannot be used. However, the module cannot be blown off and the soldering pad may be damaged if the pry bar is used. What is the best way to disassemble and solder this module? How to solder it?
This post is from PCB Design

Latest reply

Put it on the soldering station, heat the bottom of a large area, and push it down with tweezers   Details Published on 2020-1-20 13:25
 

1048

Posts

1

Resources
2
 
Use the soldering iron to brush the tin back and forth. If you are not skilled, use two soldering irons to heat both sides at the same time, and use tweezers to gently insert into the gap to lift up the module.
This post is from PCB Design
 
 

875

Posts

1

Resources
3
 
The stamp hole is very easy to remove. Adjust the temperature of the air gun and blow evenly. It is very easy to remove. However, pay attention to the temperature and don't damage the chip.
This post is from PCB Design
 
 
 

1

Posts

0

Resources
4
 

Put it on the soldering station, heat the bottom of a large area, and push it down with tweezers

This post is from PCB Design
 
 
 

Guess Your Favourite
Just looking around
Find a datasheet?

EEWorld Datasheet Technical Support

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号
快速回复 返回顶部 Return list