When the wifi module is not soldered, it will keep printing errors

明远智睿Lan

When the wifi module is not soldered, it will keep printing errors [Copy link]

A: When the wifi module is not soldered, it will keep printing errors. How to eliminate this error? B: Try to turn off the wifi configuration to see if it works A: I commented out these two places and found that it didn’t work B: Try to turn this off in the kernel Device Drivers-->Misc devices-->Allwinner rf module pm driver A: OK A: Can these two pins be used as io ports to control high and low levels? B: No, this is a dedicated pin

ylyfxzsx

It is estimated that the interference is caused by the suspension. Try a high-resistance pull-up and pull-down resistor.