Help, has anyone encountered this problem using the Pickit 3 Programmer programming tool?

粟樟息

Help, has anyone encountered this problem using the Pickit 3 Programmer programming tool? [Copy link]

The download has been successful, and the program is fine, but the function cannot be realized. The function can be realized by downloading with MPLAB_IDE_8_92. What is the reason? Did the Pickit 3 Programmer programming tool modify the hex file?

role_2099

Where did you get the Pickit 3 Programmer burning tool? You can try burning it with MPLAB IDE. I remember that the Pickit 3 Programmer burning tool was offline not long after it was launched on the official website. It seems that there is a problem.

role_2099

Also, try power off and reset.

电子微创意

Configuration bits need to be set separately

粟樟息

role_2099 posted on 2019-5-24 11:47 Where did the OP get the Pickit 3 Programmer burning tool? Try burning it with MPLAB IDE. I remember that the Pickit 3 Programmer burned...

This can be burned into MPLAB IDE and run, but this can't be burned with Pickit 3 Programmer

粟樟息

Electronic Micro Creativity published on 2019-5-24 15:35 The configuration bit needs to be set separately

Have you used this?

电子微创意

Posted by Su Zhangxi on 2019-5-24 17:45 Have you used this before?

Yes, the configuration bit should be configured here

davidlow2010

Questioner, is your configuration setting 0008 correct? You need to check it again, because you can perform two operations, preset and code setting, in the IDE. Also, your burning interface is not right. Is it based on MAPLAB 8.xx or MAPLABX? You need to confirm it again. In addition, installing MAPLAB and MAPLABx on the same computer requires driver switching. Did you switch before burning?