I recently found a strange problem using the st-link2 debugger and stm32cubeide. Has anyone encountered this before?

damiaa

I recently found a strange problem using the st-link2 debugger and stm32cubeide. Has anyone encountered this before? [Copy link]

I recently found a strange problem using the st-link2 debugger and stm32cubeide. Has anyone encountered this before?

The board I use is stm32f0308-disco, and the debugger is also the debugger on this board.

There is no problem using the STM32 ST-LINK Utility to operate the chip on this board .

There is no problem using stm32cubeide to operate the board. And the data downloaded by stm32cubeide can be seen in STM32 ST-LINK Utility

But use the st-link of this board to operate the stm32f051 chip of the newly made product board (should have been bought in the past 3 years).

It can only be read and written using stm32cubeide and STM32CubeProgrammer, but cannot be connected using STM32 ST-LINK Utility.

Is it because the st-link board is too old or what? Has anyone encountered this problem?

dcexpert

The software is too old and does not support new models

秦天qintian0303

This situation is quite common. IAR is even more disgusting than this.

damiaa

dcexpert posted on 2024-8-26 13:44 The software is too old and does not support new models

STM32 ST-LINK Utility I downloaded the latest official website. The chip version may be different.

ST-LINK is probably too old, but it can be upgraded to the latest version. And stm32cubeide and stm32cubeprogramer can be used, but STM32 ST-LINK Utility cannot. And I prefer to use STM32 ST-LINK Utility.

We should still support our own things.

During this period, I had to use stm32cubeprogramer.

dcexpert

damiaa posted on 2024-8-26 16:46 STM32 ST-LINK Utility I downloaded the latest official website. The chip may be a different version. ST-LINK is probably too old, but it can be upgraded...

STM32 ST-LINK Utility is a software abandoned by ST. It is no longer maintained and upgraded. The same is true for dfuse and other software. The functions are integrated into stm32cubeprogramer. However, I don’t like to use stm32cubeprogramer either. The previous software is simple, intuitive and convenient to operate.

damiaa

Today I downloaded the latest STM32 ST-LINK Utility 4.6.0 from the official website and installed it, and it actually worked.

The last one was also STM32 ST-LINK Utility 4.6.0. I don’t know why.

Gen_X

When using the STM32 ST-LINK Utility, you can recognize it by connecting it first and then plugging in the USB, because I tried to connect directly when I powered on.

If you plug in the USB LINK first and then the user board, you sometimes need to press RESET and then it will be fine because it is already connected and in the connected state. Especially when you plug in the STLINK, you often need to plug and unplug it to connect.

freebsder

It's free, but it can be upgraded quickly! Experience, don't ask why, hahahaha.