[NXP Rapid IoT Review] First give SLN-RPK-NODE an emulator

littleshrimp

[NXP Rapid IoT Review] First give SLN-RPK-NODE an emulator [Copy link]

 

It's not fun if you can't debug. I can't afford an expansion dock, so I soldered two DF12 (4.0) male connectors to an emulator and tried it. I searched many stores and finally found one that was reasonably priced and in stock.

anananjjj

The original poster's idea is good, I will try it too, you should make an adapter board

littleshrimp

anananjjj posted on 2018-12-29 08:18 The original poster's idea is good, I will try it too, you should make another adapter board

After receiving the connector, I will see if I can get the SWD line to fly out. If not, I can expand the drawing board

jj1989

Why don't the moderator just make a board and everyone can crowdfund it.

littleshrimp

jj1989 posted on 2018-12-29 09:07 Why don't the moderators make a board and everyone come to crowdfund.

What should I draw on the board?

shihuntaotie

Make an emulator and add a click-compatible interface

jj1989

littleshrimp posted on 2018-12-29 09:10 What should I draw on the board?

You can refer to Hexiwear Docking Station. https://www.mikroe.com/hexiwear-docking-station It's too expensive, so it's better to do it yourself.

littleshrimp

jj1989 posted on 2018-12-29 14:12 You can refer to Hexiwear Docking Station. https://www.mikroe.com/hexiwear-docking-station It’s too expensive, it’s better to make it yourself...

I can’t afford their modules to make this docking station

dvd1478

Is it easy to lead out the wires? Take a look at the picture above! ~

littleshrimp

dvd1478 posted on 2019-1-11 11:18 OP, is it easy to lead out the wire? Take a look at the picture above! ~

No, you can't fly the wire without making a board

dvd1478

littleshrimp posted on 2019-1-11 12:32 No, I can't fly the wires without making a board

OP, please do a crowdfunding! ~ Rapid IoT Studio is a bit difficult to use