qoistoochee128

NCP1618MM500WGEVB: NCP1618MM500WGEVB - 500W Evaluation Board

NCP1618MM500WGEVB: NCP1618MM500WGEVB - 500W evaluation board

Overview

The NCP1618A is an innovative multimode power factor controller. The circuit naturally transitions from one operation mode (CCM, CrM or DCM) to another depending on the switching period duration so that the efficiency is optimized over the line/load range. In very light-load conditions, the circuit enters the soft-SKIP mode for minimized losses. Housed in a SO-9 package, the circuit further incorporates the features necessary for building robust and compact PFC stages, with few external components.
The evaluation board is a 500-W wide-mains PFC stage.

Design Files

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2024-11-22 12:10:47

CC2540 novice learning to send strings
/***************************************//* CNPF *//* CC2540 BlueTooth 4.0 learning routine *//*Routine name: Serial communication 1 *//* Creation time: 2018/05/25 *//* Description: You can see it con
If you study electrical engineering, what should you learn in these four years?
1. In the first and second years of college (laying the foundation) , you must first understand that electrical majors can be divided into two directions: strong electricity and weak electricity. Spec
GPS signal acquisition problem under ZSTACK protocol stack
I am doing an experiment of a Zigbee terminal receiving GPS signals and sending them to the coordinator. However, under the ZSTACK protocol stack, there is no response after the CC2530 is connected to
Powering Smart Homes with the bq25606 Simple Charger
[i=s]This post was last edited by qwqwqw2088 on 2020-7-16 16:58[/i]Advances in wireless connectivity and low-power embedded processing have enabled new applications for smart homes and buildings. Most
Active and passive cell balancing for battery packs
[i=s]This post was last edited by qwqwqw2088 on 2019-11-17 21:40[/i]Multi-cell batteries are typically built as arrays of cells connected in series or parallel.Too many cells in series will result in
Characterization of frequency stability in the design of continuous wave radar speed measurement accuracy
Abstract In the design of continuous wave radar speed measurement accuracy, the frequency short stability of the transmitting source is one of the important factors affecting the speed measurement acc

Datasheet More

Circuits More