Energy-saving synchronous rectification, the three-terminal coil is connected, the positive and negative are added to the ground, and the positive and negative coils are required to be symmetrical. The size is 10*10mm. The power supply of the rectifier chip has voltage withstand requirements. You need to use diodes to build the same circuit first and test that the output voltage is less than the power supply limit, and then remove and solder it to avoid burning the chip.
All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.
It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.
Supported by EEWorld Datasheet