The course has a total of 63 lectures, from the introduction to the practice of 51 microcontrollers, systematically explaining the knowledge of microcontrollers in an all-round way.
This paper introduces the first closed-loop control card for hydraulic injection molding machines in China that the author participated in developing at Chen Hsong. The necessity of developing the con
This design uses the Lingyang 16-bit single-chip microcomputer SPCE061A to control the stepper motor. The square wave with timing output through the IO port is used as the control signal of the steppe
The driver of DS1302 was completed before the holiday. The date and time can be read from DS1302 and written. But the date and time need to be adjusted by using a button. It took nearly a week to make
1. bq34z100 current calibration problem:
1. In the current calibration section of the bq34z100EVM Wide Range Impedance Track Enabled Battery Fuel Gauge Solution manual, sentence 4: Connect and measure