Training

Location:Training / Embedded Development / MCU / Teach you step by step how to learn 51 microcontroller / Lecture 50

You can log in to your eeworld account to continue watching：
Lecture 50
Login

Duration：12 minutes and 32 seconds
Date：2016/05/06

Uploader：tiankai001

Introduction

keywords： Microcontroller 51 microcontroller Video tutorial

The course has a total of 63 lectures, from the introduction to the practice of 51 microcontrollers, systematically explaining the knowledge of microcontrollers in an all-round way.

You Might Like

Recommended Posts

Surface Wave Filters in RF Circuits: Radio frequency interference has always been the enemy of wireless communications, requiring designers to take drastic measures to keep it in check. With more and more frequency bands supported in eac; btty038 RF/Wirelessly

[KW41 Competition Work Submission] Intelligent Wire Rope Electromagnetic Nondestructive Testing Sensor: [i=s]This post was last edited by bjemt on 2017-7-23 22:38[/i] [align=left][font=等线][color=#000000](1) Name of the work: Intelligent electromagnetic non-destructive testing sensor for wire rope[/color; bjemt NXP MCU

Inductor selection issues: Hey guys, I have a question about inductor selection. As shown in the figure, after SENSOR_A_CTR3 (the charging circuit is not attached below), LC starts to oscillate, and SENSOR_A_IN directly enters; bingdongshijian Analog electronics

The story of motor drive integration: Just like every MOSFET needs a gate driver to switch it, there is always a driving force behind every motor. There are many ways to drive a motor, depending on the complexity and system cost, size and; Jacktang Analogue and Mixed Signal

MSP430 interrupt priority and interrupt nesting (and easy to understand error instructions): The interrupt priority of MSP430 is arranged according to the size of the vector where it is located. The higher the interrupt vector address, the higher the priority. However, the default MSP430 cann; Aguilera Microcontroller MCU

Capture circuit for rising edge (code): A simple rising edge detection code: reg RS_r1,RS_r2; always @ (posedge CLKIN or posedge RESET)if(RESET)RS_r1elseRS_r1 always @ (posedge CLKIN or posedge RESET)if(RESET)RS_r2elseRS_r2wire pos_RS = RS_; eeleader FPGA/CPLD

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号