• You can log in to your eeworld account to continue watching:
  • Step response of a first-order circuit
  • Login
  • Duration:35 minutes and 33 seconds
  • Date:2021/06/14
  • Uploader:老白菜
Introduction
01 Physical phenomena and circuit models in circuits, basic physical quantities in circuits

02 Resistance, capacitance, inductance components and characteristics

03 Digital multimeter to measure resistance

04 Independent power supply in the circuit, Kirchhoff's law

05 Kirchhoff's law micro course

06 Circuit Summary of the basic concepts and laws of circuits, exercise lesson (1)

07 Summary of the basic concepts and laws of circuits, exercise lesson (2)

08 Series and parallel equivalent transformation of resistors; star-angle transformation of resistors; equivalent transformation of power supply

09 Power supply The

equivalent transformation

of ​ ​ ​1) 16 Phasor representation of sinusoidal quantity (2), phasor form of basic circuit laws 17 Impedance and admittance 18 Phasor method solution of sinusoidal AC circuit 19 Power and calculation, power factor and improvement of sinusoidal AC circuit 20 Resonant circuit 21 Mutual inductance circuit (1) 22 Mutual inductance circuit (2) 23 Calculation of ideal transformer and circuit 24 Three-phase power supply and three-phase load 25 Calculation of three-phase power 26 Calculation of symmetrical three-phase circuit 27 Characteristics and analysis of asymmetrical three-phase circuit 28 Harmonic analysis of non-sinusoidal signals, harmonic analysis of non-sinusoidal signals effective value, average value, average power 29 Analysis of non-sinusoidal periodic current circuits 30 Dynamic process and dynamic response of the circuit 31 Determination of the initial conditions of the circuit 32 Solving the first order Three-element method of circuit dynamic response 33 Classification of first-order circuit response 34 Step response of first-order circuit 35 Laplace transform and its basic properties 36 Partial fraction expansion method of inverse Laplace transform 37 Complexity of linear circuits Frequency domain method to solve 38 Equations and parameters of two-port network (1) 39 Equations and parameters of two-port network (2) 40 Equivalent circuit of two-port network, cascade of two-port network 41 Nonlinear resistor components and their characteristics, Graphical method of nonlinear circuit 42 Small signal analysis method of nonlinear resistor circuit 43 Application of superposition theorem 44 Thevenin's theorem - determination of equivalent parameters of active two-terminal network 45 Simulation application: DC circuit analysis 46 Improvement of power factor 47 AC Mutual inductance in circuits 48 Measurement of three-phase circuits










































































Unfold ↓

You Might Like

Recommended Posts

Do you use assembly language a lot for embedded development?
I know which forum to post this thread. I am a DSP developer and use the DM643 test box of Hezhongda (by the way, the after-sales service of Hezhongda is really bad). Some of the files in the routines
colin.yao Embedded System
The first domestic Samsung A8 development board-S5PC100
S5PC100 - Mobile application processor based on ARMcortex A8 The S5PC100 uses a 32-bit ARMcortex A8 reduced instruction set processor, a 64/32-bit internal bus structure, and a maximum operating speed
yinfei0809 Embedded System
5438 CD-ROM data (development board program)
5438 CD-ROM data (development board program)
xudana Microcontroller MCU
6Lowpan introduction about roll and CoAP, zigbee players should pay attention
[i=s] This post was last edited by dan158185 on 2015-11-30 14:00[/i] Basic introduction block diagram [b][size=4][color=#0000ff]You can view the following document. Compared with the boring RFC protoc
dan158185 RF/Wirelessly
Urgent help! Why does it still report undeclared identifier when I define m_osWrite?
I am writing an MFC program in EVC. I have defined m_osWrite, but I still get an error. I don’t know why, as follows: OVERLAPPED m_osWrite; memset(&m_osWrite,0,sizeof(OVERLAPPED));//This line reports
liulei3068 Embedded System
CC2530+PA network access is related to buttons? ? ? ?
CC2530+PA network access is related to buttons? After adding HAL_KEY=FALSE in pre-compilation, it can access the network, but once HAL_KEY=TRUE, it cannot access the network?
1021256354 RF/Wirelessly

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号