[i=s]This post was last edited by sylar^z on 2019-7-30 17:43[/i]This porting of the X-NUCLEO-IKS01A3 sensor driver is based on the STM8S-DISCOVERY development board, using the official en.x-cube-mems1
sylar^zST Sensors & Low Power Wireless Technology Forum
Dear teachers, after my TMDSEVM572X development board is started using the SD card (it can operate the matrix on the LCD screen), when I use the XDS200 emulator (helloworld project), the following inf
Hardware characteristics of DS18B20: DS18B20 chip integrates 64-bit ROM (read-only memory) to store the unique serial code of each DS18B20. Therefore, if MCU wants to access a DS18B20 in the future, i
The circuit is required to amplify the signals of 24 probes. The signal output by the probe is a 10KHz sine wave current signal. From the perspective of the probe, the amplifier input impedance is req