• Duration:10 minutes and 14 seconds
  • Date:2020/03/31
  • Uploader:Lemontree
Introduction
keywords: FPGA clock Periphery
The necessary peripheral circuits required for FPGA operation are explained in detail, including: power supply, clock, configuration circuit, and some commonly used peripheral circuits are introduced.
Unfold ↓

You Might Like

Recommended Posts

Connect the hardware
After analyzing the schematic diagram, the SD card uses the SPI3 driver. For convenience, it is used to drive the ws2812b rgb led, and only its MOSI pin is used.According to the above figure, the MOSI
dql2016 MEMS sensors
U drive problem
I want to know if with the USB port driver, I can self-check the plugging and unplugging of USB port devices?
hyz5122 Embedded System
MOS tubes often break down
I wanted to test the drain current of the two MOS tubes, but I found that the DS of Q1 tube often broke down. I don't know what the problem is.
zk643 Analog electronics
Can LM3S be directly connected to 5V chips such as HC and LS? Thank you.
Can LM3S be directly connected to 5V chips such as HC and LS? Thank you.
o0pingu0o Microcontroller MCU
SHT10 FPGA Driver
`timescale 1ns/1ns module Sht10 ( input wire rst, //system reset signal input wire clk, //20MHZ clock input wire rd ,input wire rd_clk, // input wire clk1ms, output reg scl, //serial clock signal inou
eeleader FPGA/CPLD
AD How to use the bottom layer silk screen to print out the drawing?
The operation suddenly did not work properly. Please help.
btty038 PCB Design

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号