Training

Location:Training / Hot Applications / Industrial Control / Automatic control principle stone group / 00

Duration：10 minutes and 15 seconds
Date：2019/07/29

Uploader：JFET

Introduction

keywords： automatic control Postgraduate Entrance Examination

Detailed and practical "automatic control principles (including modern control theory) video tutorials" taught in accordance with postgraduate entrance examination standards! This series of video tutorials are all taught by Dr. Shi Qun of Tsinghua University.

You Might Like

Recommended Posts

Harmonic flicker test solution-EMI test system: [p=null, 2, left]The voltage fluctuation and flicker test mainly measures the changes in the grid voltage caused by the EUT. The interference effect caused by voltage changes depends not only on the a; bjhyyq Industrial Control Electronics

DSP interrupt path flow chart: Any peripheral or external interrupt that contains the PIE interrupt source, and its own peripheral interrupt module can also be enabled.PIE recognizes INTx.y, and the bit of PIE interrupt is Latched,; 灞波儿奔 DSP and ARM Processors

Detailed explanation of terminal device state switching in TI ZigBee protocol stack: This article mainly introduces the detailed description of the switching between different states during the operation of the terminal device End Device in TI ZigBee protocol stack Z-Stack, and furthe; Jacktang Wireless Connectivity

ICL 5101 usage advice,: I have been studying the ICL5101 MOSFET recently, and I am going to make a dimmable LED driver, because it integrates Boost PFC and resonant half-bridge control circuits, and the peripheral circuit de; 闰川先生 LED Zone

DSP Control Problems of BLDC: Hello, teachers. I am currently working on the control of BLDC from open loop to speed closed loop. I am using TI's BLDC-sensored routine. When running in open loop, the circuit waveform of the motor; studyking Analog electronics

Understand low-pass, high-pass, band-pass, band-stop, and state-adjustable filters at once!: The second-order voltage-controlled low-pass filter circuit is shown in the figure. R1, C1 and R2, C2 respectively form two first-order low-pass filters, but C1 is connected to the output end to intro; 灞波儿奔 Analogue and Mixed Signal

推荐文章

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号