• Duration:13 minutes and 30 seconds
  • Date:2019/05/20
  • Uploader:木犯001号
Introduction
keywords: MATLAB PID simulink
This series provides an introduction to proportional-integral-derivative (PID) control.
PID is just one form of feedback controller, and it can be fairly easy to understand and implement. It is the simplest type of controller that uses the past, present, and future error, and it’s these primary features that you need to satisfy most control problems. That is why PID is the most prevalent form of feedback control for a wide range of real applications.
Often, when learning something new in control theory, it’s easy to get bogged down in the detailed mathematics of the problem. So in this series, we’re going to skip most of the math and instead focus on building a solid foundation.
Unfold ↓

You Might Like

Recommended Posts

I just installed AD17, but I can't set Keep-OutLayer
I just installed AD17, but I can't set Keep-OutLayer. I can't modify it to mechanical layer or other layer in batches or individually. Does anyone know where to set it? It's urgent. Thank you!
zttian PCB Design
Simple method to determine the polarity of thermocouple
When the thermocouple has no polarity marking, in addition to using a multimeter to detect it, the simplest method is to use a magnet to judge, but it can only judge the commonly used types such as K,
totopper Industrial Control Electronics
Could you please help me look at the STM32 external interrupt and why I can't enter the interrupt.
The code is as follows: void Exit_Init(void) { RCC->APB2ENR|=1CRL&=0XFFFFFFF0;//Set to input GPIOA->CRL|=0X00000008; GPIOA->ODR|=1PR=1>NVIC_Group); temp&=0xf; //Take the lower four bits if(NVIC_Channe
abcd5867 stm32/stm8
Wince5 compile SDK error
If you click Yes to continue, you may receive the following error message that is generated by the SDK build:Rolling sysgen'ed headers and libs…Error: This build configuration has not been sysgen'edEr
jasonb Embedded System
LPCXpresso LPC1114 SSP multi-sector read and write SD card
In order to more clearly explain the difference between multi-sector and single-sector reading and writing, a separate post is opened for detailed explanation.When porting the FatFs file system, I fou
zhaojun_xf NXP MCU
How to set specific spacing rules for each pad when laying the floor in Altium Designer
I know how to set "all", "network", "network class" and "layer" below where the first object matches. How to use "network and layer" and "advanced (query)"? What is the difference between where the se
张寅平 PCB Design

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号