Training

Location:Training / Embedded Development / Microcomputer Principles and System Design / Bus and its formation (8)

You can log in to your eeworld account to continue watching：
Bus and its formation (8)
Login

Duration：22 minutes and 5 seconds
Date：2019/02/23

Uploader：木犯001号

Introduction

keywords： bus Microcomputer principles 8086

This series introduces the principles and system design of microcomputers, the number system and code system in computers, the structure and functions of 8086CPU, 8086CPU instruction system, assembly language programming, bus and its formation, memory design, and interface technology of commonly used chips

You Might Like

Recommended Posts

R7F0C80212 kit trial development environment construction 2---code automatic generation tool code generator: [i=s]This post was last edited by yang_alex on 2014-9-8 08:05[/i] Development Environment Construction for R7F0C80212 Kit Trial 2 --- Code Generator I have seen several automatic code generators from; yang_alex Renesas Electronics MCUs

How to set up GPRS modem dial-up in Windows XP?: Under Windows XP, I have a GPRS modem connected via a serial port. At the same time, there is a phone modem on the PC. Every time I set "connect using a dial-up modem", the phone modem is always autom; lemonnofeeling Embedded System

How to set ADC reference voltage?: The ADC gets the voltage value of a certain point, the range is only 0~1.65v, isn't the internal reference voltage of M4 3.3v? I used ADCReferenceSet (ADC0_BASE,ADC_REF_INT); but the result is useless; G_Masker Microcontroller MCU

[Ufun learning part 1] unboxing and SWD debugging: I just returned to school a few days ago, and the courier kept urging me to deliver the board. If I came back a few days later, this cute little board would have to say goodbye to me. I couldn't wait; shannon2014 stm32/stm8

Design of heterogeneous pads in AD9: As shown below, QFN-10 package, center thermal pad. The heterogeneous pad cannot be drawn. In PCB, use wire to draw the shape, and then convert it to region. When copied to the package editing interfa; 呜呼哀哉 PCB Design

Help: I am using the ordinary I/O of the microcontroller to simulate IIC, writing one byte to the E2PROM, and then reading it out for verification. It works, but there is an error. I don't know if it is a r; gaorenxiang MCU

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号