• Duration:1 hours and 44 minutes and 53 seconds
  • Date:2019/03/21
  • Uploader:EE大学堂
Introduction
This video will start from the simplest to the deeper, leading everyone to learn the various functions of STM32F103, and start a new STM32 journey for you.
This video is divided into three parts:
1. Introductory part, which mainly introduces the basic knowledge of STM32;
2. Intermediate part, mainly introduces the use of STM32 basic peripherals, including: GPIO, serial port, timer, external interrupt, etc. After studying this article, you will have a basic introduction to STM32 development.
3. Advanced chapter, mainly introduces STM32 advanced peripherals, including: SDIO, CAN bus, etc.
Unfold ↓

You Might Like

Recommended Posts

Notes and lessons about IAR installation
[backcolor=white][size=4][color=#000000]As a novice in embedded programming, I first need to install the embedded system development tool IAR, of course, the cracked version. But I encountered some pr
Jacktang Microcontroller MCU
Dear forum friends, please share how many days you have off and whether you have been working.
I'll go first. We'll start tomorrow - February 9th. It's a bit relaxing.
yangyi1818 Talking
How to open serial port com1?
Why does it always say that the serial port cannot be opened every time I connect to the serial port? Very depressed! The prompt is: unable to open serial com1: The system cannot find the specified fi
xlhl3 Embedded System
How to draw block circuits using AD?
As shown in the board, all components in the circuit are immersed in the block.
bigbat PCB Design
[Open Source] Bluetooth module BT401 full set of information based on Bluetooth headset chip development ultra-low cost
Bluetooth, an ancient and excellent technology, has brought many stories with the launch of Apple's AirPods. As a practicing engineer, I would like to share with you some of the stories about it, main
qyvhome 51mcu
Problems connecting to GSM module
I would like to ask, what should I pay attention to when installing the GSM module? I want to use the hyperterminal to debug it first, but I don’t dare to power it on for fear of burning it. What shou
phlelp Embedded System

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号