The iPhone 12 has just started selling, and some people can't wait to share the news about the iPhone 13. If the news is reliable, the new generation of iPhone 13 may have both Touch ID fingerprint + Face ID biometric sensors. Given that manufacturers usually start developing new models a year in advance, Apple may have been researching the prototype design of the iPhone 13 in its own secret laboratory.
Looking back at the months before the launch of iPhone X, there were a lot of reports that the phone would use an under-screen fingerprint sensor to replace the Touch ID sensor. But in September 2017, the popularity of Face ID began to surpass it.
However, with the onset of the COVID-19 global health crisis, the wearing of personal protective equipment by users has once again brought people back to reality - Face ID cannot accurately recognize 3D faces under masks, forcing many iPhone users to use PIN codes to unlock them tirelessly.
The good news is that @L0vetodream pointed out in a recent tweet that Mesa is the internal code name of Touch ID, and uts may refer to "Under the Screen".
Since the concept of under-screen fingerprint sensors emerged, manufacturers have been mainly divided into two camps: optical and ultrasonic recognition. However, at the first autumn new product launch conference last month, Apple introduced the Touch ID sensor solution integrated with the power button for the iPad Air 4, which is unprecedented.
Previously, Apple has experimented with introducing Touch ID sensors integrated with the power button for its MacBook Air and MacBook Pro notebook lines, but the iPad Air 4 is its first introduction for an iOS/iPadOS device.
This solution has proven to be very effective during the COVID-19 pandemic. However, when the iPhone 12 project was launched, no one obviously expected the global health crisis to last so long.
The good news is that Apple can at least consider reintroducing the Touch ID solution for the next generation of models from now on, whether it is based on under-screen recognition or physical buttons. If so, the iPhone 13 may become the first Apple smartphone equipped with both Touch ID and Face ID.
In addition, there are reports that Apple may be developing an iPhone without a notch, and it is speculated that the company may consider introducing a hidden front camera and Face ID components under the screen. As for the truth, it remains to be seen.
Previous article:BOE may supply OLED to Apple by the end of the year, but only for non-Pro models
Next article:How much does it cost to replace the iPhone 12 series screen? Apple gives the answer
Recommended ReadingLatest update time:2024-11-16 12:46
- Popular Resources
- Popular amplifiers
- Apple faces class action lawsuit from 40 million UK iCloud users, faces $27.6 billion in claims
- Apple and Samsung reportedly failed to develop ultra-thin high-density batteries, iPhone 17 Air and Galaxy S25 Slim phones became thicker
- Micron will appear at the 2024 CIIE, continue to deepen its presence in the Chinese market and lead sustainable development
- Qorvo: Innovative technologies lead the next generation of mobile industry
- BOE exclusively supplies Nubia and Red Magic flagship new products with a new generation of under-screen display technology, leading the industry into the era of true full-screen
- OPPO and Hong Kong Polytechnic University renew cooperation to upgrade innovation research center and expand new boundaries of AI imaging
- Gurman: Vision Pro will upgrade the chip, Apple is also considering launching glasses connected to the iPhone
- OnePlus 13 officially released: the first flagship of the new decade is "Super Pro in every aspect"
- Goodix Technology helps iQOO 13 create a new flagship experience for e-sports performance
- Innolux's intelligent steer-by-wire solution makes cars smarter and safer
- 8051 MCU - Parity Check
- How to efficiently balance the sensitivity of tactile sensing interfaces
- What should I do if the servo motor shakes? What causes the servo motor to shake quickly?
- 【Brushless Motor】Analysis of three-phase BLDC motor and sharing of two popular development boards
- Midea Industrial Technology's subsidiaries Clou Electronics and Hekang New Energy jointly appeared at the Munich Battery Energy Storage Exhibition and Solar Energy Exhibition
- Guoxin Sichen | Application of ferroelectric memory PB85RS2MC in power battery management, with a capacity of 2M
- Analysis of common faults of frequency converter
- In a head-on competition with Qualcomm, what kind of cockpit products has Intel come up with?
- Dalian Rongke's all-vanadium liquid flow battery energy storage equipment industrialization project has entered the sprint stage before production
- Allegro MicroSystems Introduces Advanced Magnetic and Inductive Position Sensing Solutions at Electronica 2024
- Car key in the left hand, liveness detection radar in the right hand, UWB is imperative for cars!
- After a decade of rapid development, domestic CIS has entered the market
- Aegis Dagger Battery + Thor EM-i Super Hybrid, Geely New Energy has thrown out two "king bombs"
- A brief discussion on functional safety - fault, error, and failure
- In the smart car 2.0 cycle, these core industry chains are facing major opportunities!
- The United States and Japan are developing new batteries. CATL faces challenges? How should China's new energy battery industry respond?
- Murata launches high-precision 6-axis inertial sensor for automobiles
- Ford patents pre-charge alarm to help save costs and respond to emergencies
- New real-time microcontroller system from Texas Instruments enables smarter processing in automotive and industrial applications
- #SpaceX sends 4 civilians into space#When can I travel in space too???
- Please tell me the circuit composed of TL431 directly and optocoupler inside the power supply
- The problem of via aperture and line width
- Use one data line to control full-color LED lights! Single bus LED usage guide
- 【Portable Programmable Meter】Sliding Rheostat Arrived
- Linux environment programming: from application to kernel
- How to connect the reed switch sensor to the microcontroller
- ssh network login
- The 200-meter line signal has irregular jumps after the op amp output
- 【GD32F307E-START】+ Completed driving LCD19264 display