Relay:
The relay is marked with: AC stands for alternating current, the bottom line 05V is the rated voltage of 5V, and the 30VDC below stands for 30V direct current.
Relay circuit diagram connection: as shown in the middle part of the figure below;
(1) 4 and 5 are D and E;
(2) 2 is normally open, 3 is normally closed;
(3) 1 and 3 form a closed state, and 1 and 2 form an open state;
Reason for using an armature: The armature will not be magnetized.
Freewheeling diode:
》Working principle: (Use knowledge related to induced electromotive force to understand) Therefore, the freewheeling diode needs to be turned on quickly after the circuit is cut off.
Previous article:Detailed analysis of the working principle of 74HC595 chip
Next article:51 single chip microcomputer ~ four demonstration methods of running lights
- Popular Resources
- Popular amplifiers
- Learn ARM development(16)
- Learn ARM development(17)
- Learn ARM development(18)
- Embedded system debugging simulation tool
- A small question that has been bothering me recently has finally been solved~~
- Learn ARM development (1)
- Learn ARM development (2)
- Learn ARM development (4)
- Learn ARM development (6)
Professor at Beihang University, dedicated to promoting microcontrollers and embedded systems for over 20 years.
- LED chemical incompatibility test to see which chemicals LEDs can be used with
- Application of ARM9 hardware coprocessor on WinCE embedded motherboard
- What are the key points for selecting rotor flowmeter?
- LM317 high power charger circuit
- A brief analysis of Embest's application and development of embedded medical devices
- Single-phase RC protection circuit
- stm32 PVD programmable voltage monitor
- Introduction and measurement of edge trigger and level trigger of 51 single chip microcomputer
- Improved design of Linux system software shell protection technology
- What to do if the ABB robot protection device stops
- CGD and Qorvo to jointly revolutionize motor control solutions
- CGD and Qorvo to jointly revolutionize motor control solutions
- Keysight Technologies FieldFox handheld analyzer with VDI spread spectrum module to achieve millimeter wave analysis function
- Infineon's PASCO2V15 XENSIV PAS CO2 5V Sensor Now Available at Mouser for Accurate CO2 Level Measurement
- Advanced gameplay, Harting takes your PCB board connection to a new level!
- Advanced gameplay, Harting takes your PCB board connection to a new level!
- A new chapter in Great Wall Motors R&D: solid-state battery technology leads the future
- Naxin Micro provides full-scenario GaN driver IC solutions
- Interpreting Huawei’s new solid-state battery patent, will it challenge CATL in 2030?
- Are pure electric/plug-in hybrid vehicles going crazy? A Chinese company has launched the world's first -40℃ dischargeable hybrid battery that is not afraid of cold
- What are the methods of remote communication? Which manufacturers have used specific products?
- Regarding "Circuit Design Based on Operational Amplifiers and Analog Integrated Circuits", there is a concept of "Pole" that is not clear
- RISC-V IDE MRS usage notes (Part 3): Improving floating-point calculation efficiency
- Another question about the matrix keyboard
- Understanding of MSP430 interrupt mechanism
- Understand some misunderstandings about FPGA learning
- Transmit power measurement method
- My Journey of MCU Development (VI)
- [RVB2601 Creative Application Development] 4 Long press and short press to eliminate the letter A
- CC2520 BasicRF Study Notes