The following figure is the main control circuit schematic diagram of the two-color clock without hands of the single-chip microcomputer. As shown in the figure: the AT89S51 single-chip microcomputer is used as the control core, and the 74LS154 (4-16 line decoder) is used to expand the I/O port to control the display of the clock. 12 red LED lights are used to represent hours, and 12 green LED lights are used to represent minutes, which change every 5 minutes. Only two LED lights are on at the same time, which is energy-saving, convenient, easy to identify, and full of personality.
Previous article:Interface and programming method between LCD and single chip microcomputer
Next article:Design of street lighting power saving control system with remote monitoring
- Popular Resources
- Popular amplifiers
Professor at Beihang University, dedicated to promoting microcontrollers and embedded systems for over 20 years.
- LED chemical incompatibility test to see which chemicals LEDs can be used with
- Application of ARM9 hardware coprocessor on WinCE embedded motherboard
- What are the key points for selecting rotor flowmeter?
- LM317 high power charger circuit
- A brief analysis of Embest's application and development of embedded medical devices
- Single-phase RC protection circuit
- stm32 PVD programmable voltage monitor
- Introduction and measurement of edge trigger and level trigger of 51 single chip microcomputer
- Improved design of Linux system software shell protection technology
- What to do if the ABB robot protection device stops
- Huawei's Strategic Department Director Gai Gang: The cumulative installed base of open source Euler operating system exceeds 10 million sets
- Download from the Internet--ARM Getting Started Notes
- Learn ARM development(22)
- Learn ARM development(21)
- Learn ARM development(20)
- Learn ARM development(19)
- Learn ARM development(14)
- Learn ARM development(15)
- Analysis of the application of several common contact parts in high-voltage connectors of new energy vehicles
- Wiring harness durability test and contact voltage drop test method
- Playing with AT32F437 (3) --- USB OTG peripherals encounter strange practices
- Shanghai is urgently recruiting FPGA development engineers with generous benefits! ! ! !
- CircuitPython-controlled Internet RGB matrix display
- EEWORLD University Hall ---- Teacher Tang explains the real questions of the electronic competition
- Touch button based on MSP430
- Motor control circuit, MOS burnt out
- I would like to ask a question about the discrete device BUCK circuit
- The idle "four-piece set", have the contemporary young people collected them all?
- There was an earthquake. There have been too many earthquakes in the past two days.
- National Technology Virtual Serial Port/CDC and Development Board Onboard NS_LINK Driver