Performance characteristics and applications of OTM2610+OTM2602 10G packet network tester

OTM2610+OTM2602 10G packet network tester supports the functions of traditional Ethernet testers and provides a comprehensive testing solution for the installation and maintenance of metro Ethernet and IP services. The complete testing capabilities of OTM2610+OTM2602 provide on-site technicians with end-to-end 10/100/1000/10000M transmission links, 10G Ethernet links and IP network bit error performance testing to determine link utilization and throughput. , latency and IP connectivity.

OTM2610+OTM2602 also provides comprehensive test solutions for the latest packet networks, including SLA test functions and OAM test functions according to the ITU-T Y.1564 Ethernet service verification method standard. Y.1564 can test current mobile backhaul network and carrier-grade Ethernet network services. The OAM test function supports new protocols such as IEEE 802.3ah, IEEE 802.1ag, ITU-T Y.1731 and ITU-T G.8113.1 OAM link and service protocols, which makes it easier to maintain packet networks.

The main function:

One 10G Base-X test interface

Two 10/100/1000M Base-T, 100M Base-FX, 1000M Base-X test ports, supporting full-duplex and half-duplex adaptation of all interfaces

Throughput, back-to-back, latency and frame loss measurements (bidirectional results) per RFC 2544

Complete Y.1564 test suite (bidirectional results). Y.1564 provides comprehensive field testing for mobile backhaul and commercial services

Supports OAM test functions based on ITU-T 802.3, ITU-T Y.1731 and ITU-T G.8113.1 standards

Supports online business scanning based on destination/source MAC, destination/source IP, Layer 3 VLAN ID, and Layer 3 MPLS Label

10G supports up to 512 data flow generation and analysis, providing throughput, latency, frame loss and packet jitter measurements for each data flow

Supports packet jitter testing based on the RFC3393 standard to evaluate IP packet delay changes

Support ***PING test function of specified IP address pool

The Gigabit interface supports master-slave simulation testing of IEEE1588v2 PTP and Sync-E

Gigabit interface supports unicast and multicast PTP information transmission methods

The Gigabit interface supports PTP information mapping of PTP message over Ethernet and PTP message over UDP over IPv4.

Gigabit interface supports real-time statistics of various sent and received PTP messages

The Gigabit interface supports the simulation and analysis of Synchronous Ethernet ESMC information based on the ITU-T G.8264 standard

Layer1 to Layer4 bit error, loopback and remote intelligent loopback testing

Push-through testing with the ability to insert network impairments during the push-through process to verify network performance

Service outage testing

application:

Packet network performance qualification; network planning

Large customer dedicated line network performance evaluation

BERT, RFC2544 and SLA verification testing

Synchronous service activation