Simulink Modeling and Simulation-Others-EEWORLD

Recommended ContentMore

Open source project More

Searched by Users

Just Take a LookMore

bluenrg-2 cannot connect to other devices directly when it is the host
After successful initialization, the function aci_gap_create_connection is used to connect directly according to the address, but it returns 0x46 BLE_STATUS_NOT_ALLOWED. The connection cannot be succe
Playing with Zynq Serial 43——[ex62] Image Laplace Edge Extraction of OV5640 Camera
1 System Overview As shown in the figure, this is the principle block diagram of the entire video acquisition system. At the beginning of power-on, the FPGA needs to initialize the register configurat
[NXP Rapid IoT Review] + First try of mobile APP
After learning that I had the honor to participate in the NXP Rapid IoT evaluation, I started to install the mobile APP. According to my previous experience, I chose to use my mobile phone to log in t
CC2541 Key Fob Reference Design
A Bluetooth Smart Key Fob is a small, coin-cell powered mobile phone accessory that features buttons, a buzzer, LEDs, and an accelerometer, and embodies the use of BLE GATT service profiles such as th
Give feedback on Lingdong Micro's MM32F013x library functions and routines
I am going to use the CAN bus recently. I have three boards with CAN transceiver PHY, a TMS320F28377S LAUNCH, a GD32VF103V EVAL, and a MM32 eMiniBoard. I remember that I had a small board with CAN PHY
Design of wireless voice communication system based on Mesh technology
[Domestic RISC-V Linux Board Fang·Starlight VisionFive Trial Report] Environment Preparation——Install MySQL
Project Management (Passive Components)
Could you please tell me what is the name of the plastic film wrapped around the outside of the transformer?
About the power supply of the circuit board

Trending Downloads

Simulink Modeling and Simulation

Document Introduction