1. bq34z100 current calibration problem:
1. In the current calibration section of the bq34z100EVM Wide Range Impedance Track Enabled Battery Fuel Gauge Solution manual, sentence 4: Connect and measure
LZ is in the second year of graduate school. Although his major is electronics, the application is awkward. It is in the direction of electronic readout for large-scale particle detection. With the ec
The WM signal is a digital signal with a fixed period and an indefinite duty cycle.If the counter of Timer_A works in the up-counting mode, the output adopts the output mode 7 (reset/set mode)to contr
Because the op amp is powered by a single power supply, a bias voltage VCM1 of tens of mV must be added (why?). I see that the classic differential amplifier circuits are all grounded? Also, I used a
1. Introduction
In the last post, I wanted to test the production program, but after consulting and posting, I seem to know that the program is not included when it leaves the factory. Today, I will p