USB interface design based on PL2303-Electron circuit-EEWORLD

Recommended ContentMore

Open source project More

Searched by Users

Just Take a LookMore

Delay error
Help: The following delay program has been completed, but it is always 0.3 seconds longer (setting 0.2 results in 0.5, setting 2.3 results in 2.6...), the microcontroller uses stc15w201s, and the freq
What is a good way to convert PWM to 0-10V?
What is a good way to convert PWM to 0-10V? The method of using filter and op amp is too slow to respond.
Read the good book "Operational Amplifier Parameter Analysis and LTspice Application Simulation" 02 What is the definition of positive feedback and negative feedback of operational amplifier?
When I saw this passage while studying, it seemed different from what I learned in school. What do you think?When I was in school, I used a book on analog electronics written by Professor Hua Chengyin
06. Anlu SparkRoad domestic FPGA evaluation [Learning] RGB lights
[i=s]This post was last edited by 1nnocent on 2022-7-27 15:44[/i]The function implemented by the RGB three-color lamp routine is to light up the three colors R, G, and B alternately. I would like to s
STM32 microcontroller thanks
[i=s]This post was last edited by ddllxxrr on 2021-1-28 12:24[/i]This is how the matter originated. My company wants to modify a solution, so I will do it. I still use the old MCU STM32F100C8T6. Since
[Help] spx3819-3.3 regulated output
Is it a voltage comparator or an oscillator circuit?
Problems with the full-bridge circuit formed by dual MOS tube Si4288
Radio frequency allocation map
[National Technology N32 MCU Development Data]--Full Series Product Selection Table

Trending Downloads

USB interface design based on PL2303

Document Introduction