Used for SJA1000 baud rate calculation-Embedded Development-EEWORLD

Recommended ContentMore

Open source project More

Searched by Users

Just Take a LookMore

Problems with CPLD driving MAX7219 to transmit 8-bit parameters
I successfully used CPLD to drive MAX7219 to transmit 16-bit parameters. I see that microcontrollers transmit 8 bits of data at a time, and I also want to use CPLD to transmit 8 bits of data. But ther
220V AC to 18V DC
Using a 220V to 18V transformer, the voltage output of the transformer output (pins 12, 14, 17, 19) is 12V. After passing through the MB6S rectifier, the output voltage of pin 3 of SP1 is 27V, and the
DSPF28335 Study Notes
[i=s]This post was last edited by Aguilera on 2018-12-24 20:41[/i] [size=4]1. GPIO[/size] [size=4]GPxMUX (function selection register),[/size] [size=4] GPxMUX.bit=0 is configured as I/O function. GPxM
Anyone know what component this is?
I don't know what this capacitor is.
【AT-START-F425 Review】-Recording the use of CAN communication
【AT-START-F425 Review】- Recording the use of CAN communicationCAN communication pinAccording to the chip manual, AT32F425 PB8 = CAN_RX PB9 = CAN_TXmultiplexed port is MUX4Check the Demo project and co
HDI blind hole design, did you notice this detail?
【TI recommended course】#Give old motors new skills#
This is a brain teaser - hypotenuse, leg, chord, even Pythagorean theorem
Should the PCB trace angle not be 90°? — PCB Layout Tips
Problems with serial programming of STC89C51RC microcontroller

Trending Downloads

Used for SJA1000 baud rate calculation