A Block Floating Point Implementation for an N-Point FFT on the TMS320C55x DSP-Embedded Development-EEWORLD

Recommended ContentMore

Open source project More

Searched by Users

Just Take a LookMore

Isn't the remainder % correct? Also, why are the TH0 and TL0 registers both set to 256-t?
Isn't the remainder % correct? Also, why are the TH0 and TL0 registers both set to 256-t?
GCC GD32E230 toolchain startup and linking files
Share the GD32E230 GNU Tools for Arm Embedded Processors tool chain startup and connection files.
IoT architecture and technology protocols
This chapter introduces the technical architecture used to support Internet of Things (IoT) applications and discusses some key IoT technologies and wireless protocols in detail.Gain insights into the
Review Weekly Report 20221010: Sipeed GW2A FPGA development board and Renesas ultra-low power MCU RA2L1 are here~
Activities currently being applied for1. Sipeed GW2A FPGA development board ( newly launched ) After being evaluated and praised by engineers in our forum, the domestic Gaoyun FPGA is coming again. Th
Why can a Zener diode break down with a reverse current of just a few volts, but a rectifier diode cannot break down with a reverse current of more than 200 volts?
[i=s]This post was last edited by Shenzhen Xiaohua on 2021-2-1 21:35[/i]Why can a Zener diode break down at a reverse current of just a few volts, but a rectifier diode cannot break down at a reverse
Semiconductor Recruitment-Shanghai, Shenzhen, Hangzhou
Things to note when configuring 4G router ports
Four major reasons for the heating of power modules
[Erha Image Recognition Artificial Intelligence Vision Sensor] 3. Serial communication with the processor
(Paid Purchase) SSRP-7.25 Motherboard PCB

Trending Downloads

A Block Floating Point Implementation for an N-Point FFT on the TMS320C55x DSP

Document Introduction