DFM (Design for Manufacturing) is the core technology of concurrent engineering. Design and manufacturing are the two most important links in the product life cycle. Concurrent engineering is to consi
At DFrobot's autumn conference , a new device was released, the SCI acquisition module, which can be used to collect data from a variety of sensors produced by DFRobot without any programming.
Officia
[i=s] This post was last edited by yhye2world on 2018-12-4 17:19 [/i] Can MCx063A be used to achieve a DC12V, 1.5A output? The following figure is a screenshot of the MCx063A switching regulator speci
The Kanzhi K510 CRB development board is equipped with Canaan's latest high-performance graphics and voice processing AI chip - Kanzhi K510. It uses a RISC-V dual-core CPU @ 800MHZ , a built-in DSP co
[font=Tahoma, Helvetica, SimSun, sans-serif][size=14px]As everyone is concerned about air quality, I believe everyone is also concerned about the air quality of their living environment, such as the d