IP Rating ............................................................ IP 40 .....................................................................IP 40
*RoHS Directive 2002/95/EC Jan. 27, 2003 including annex and RoHS Recast 2011/65/EU June 8, 2011.
Specifications are subject to change without notice.
Customers should verify actual device performance in their specific applications.
Model 91, 92, 93, 94 & 95 - 5/8 ” Square Single-Turn Panel Control
Mechanical Characteristics
1
Stop Strength (1/4 ” D shaft) .............................................................................................................................................45.19 N-cm (4 lb.-in.)
(1/8 ” D shaft) .............................................................................................................................................33.89 N-cm (3 lb.-in.)
Starting ........................................................................................................................................... 0.3 max. above average running torque
Running Torque
Single or Dual Section (A & R Bushings) .................................................................................................. 0.21 to 1.06 N-cm (0.3 to 1.5 oz.-in.)
Single or Dual Section (C & U Bushings) .................................................................................................. 0.14 to 1.06 N-cm (0.2 to 1.5 oz.-in.)
Mounting .............................................................................................................................................1.7-2.0 N-m (15-18 lb.-in.) maximum
Variation ...................................................................................................................... 0.35 N-cm (0.5 oz.-in.) maximum in 45 ° shaft travel
Weight (Single Section, Metal Bushing)...............................................................................................................................12.7 grams nominal
Terminals .................................................................................................................................Printed circuit terminals, J-Hooks or solder lugs
Soldering Condition ...........................................Recommended hand soldering using Sn95/Ag5 no clean solder, 0.025 ” wire diameter.
Maximum temperature 399 °C (750 °F) for 3 seconds. No wash process to be used with no clean flux.
Marking ..................................................................................Manufacturer’s trademark, date code, resistance, manufacturer’s part number
Ganging (Multiple Section Potentiometers).............................................................................................................................2 cups maximum
Hardware ...................One lockwasher and one mounting nut is shipped with each potentiometer, except where noted in the part number.
NOTE:
1
At
Performance specifications do not apply to units subjected to printed circuit board cleaning procedures.
room ambient: +25 °C nominal and 50 % relative humidity nominal, except as noted.
Specifications are subject to change without notice.
Customers should verify actual device performance in their specific applications.
Model 91, 92, 93, 94 & 95 - 5/8 ” Square Single-Turn Panel Control
Product Dimensions
Model 91 PC Pin Terminals, In-Line
22.86 ± 0.43
(.900 ± .017)
MOUNTING
SURFACE
L
12.70 ± .229
(.500 ± .009)
0.79 ± .025
(.031 ± .010)
DIA.
13.72 ± 0.38
(.540 ± .015)
1.37 ± 0.08
(.054 ± .003)
2.36 ± 0.08
(.093 ± .003)
15.88
(.625)
7.92
(.312)
Model 92 J-Hooked
Terminals, In-Line
.79
(.031) 2 PLCS.
3 2 1
.254
(.010)
GAP
SEE
HOW TO ORDER
CHART FOR
BUSHING OPTIONS.
10.16 ± 0.30
(.400 ± .012)
11.05 ± 0.20
(.435 ± .008)
SEE
NEXT PAGE
FOR SHAFT
OPTIONS.
1.19
(.047)
“A” STYLE
A.R. LUG
R
9.53
(.375)
15.29 ± 0.56
(.602 ± .022)
5.08
(.20)
1.52
(.06)
R2
R1
1
2
3
1
2
3
2.54
(.100)
2.54
(.100)
Model 94 J-Hooked
Terminals, "L" Pattern
0.76 ± 0.05
(.030 ± .002)
TYP.
Model 93 PC Pin Terminals, "L" Pattern
22.86 ± 0.43
(.900 ± .017)
MOUNTING
SURFACE
L
12.70 ± .229
(.500 ± .009)
0.79 ± .025
(.031 ± .010)
DIA.
13.72 ± 0.38
(.540 ± .015)
1.37 ± 0.08
(.054 ± .003)
2.36 ± 0.08
(.093 ± .003)
15.88
(.625)
7.92
(.312)
3 2 1
1.52
(.06)
GAP
.81
(.032)
R. MAX.
5.33 ± .76
(.21 ± .03)
3.81
(.150)
MAX. TYP.
SEE
HOW TO ORDER
CHART FOR
BUSHING OPTIONS.
DIA.
0.81
TYP.
(.032)
10.16 ± 0.30
(.400 ± .012)
R2
R1
5.08 ± 0.38
(.200 ± .015)
11.05 ± 0.20
(.435 ± .008)
SEE
NEXT PAGE
FOR SHAFT
OPTIONS.
1.19
(.047)
“A” STYLE
A.R. LUG
R
9.53
(.375)
12.7 ± 1.02
(.500 ± .040)
Shaft Flat Orientation
2.54
(.100)
2.54
(.100)
120 ° ± 5 ° STD.
FLAT ORIENTATION
(SHAFT AT CCW END)
1
3
2
1
3
2
0.76 ± 0.05
(.030 ± .002)
TYP.
1
CCW
2
POTENTIOMETER
3
Model 95 Solder Lug Terminals, "Triangular" Pattern
Development Board Basics - Chew Slowly
CH582 is a 32-bit microprocessor based on RISCV architecture. The integrated development environment uses the MounRiver integrated development environment based ...
[i=s]This post was last edited by ljj3166 on 2020-9-13 01:53[/i]I got the WCH evaluation board for the third time.
Coincidentally, several times when I was looking for ICs, EEworld would promote a WCH...
Over the past 10 years, the number and complexity of electronic systems in automobiles have increased dramatically in terms of electronic control, in-car multimedia systems, and entertainment systems....
1. Overview OSAL (Operating System Abstraction Layer), translated as"operating system abstraction layer".OSALis a system resource allocation mechanism that supports multi-tasking.OSALis very different...
[i=s]This post was last edited by sxluo on 2021-3-16 10:14[/i]Below some news about our BLE module portfolio and mesh package documentation.BlueNRG-M0: new revision (#5) of the Datasheet, adding refer...
1. Frequency unit
2, Global Police Radar Frequencies3. Military radar frequency band4. ITU radar frequency band
5. Radio frequency band6. Electronic Countermeasures ECM Band
7. Sound wave frequency ba...
According to the German Handelsblatt, Bosch plans to lay off about 1,200 people in the software and electronics department by the end of 2026, of which 950 are in Germany. Bosch officials confirmed t...[Details]
Recently, Malaysia was hit by heavy rains, causing severe disasters in Selangor, Kuala Lumpur and other places, which also caused significant losses to local semiconductor manufacturers. According t...[Details]
True value: refers to a physical quantity that exists objectively but cannot be obtained absolutely correctly except in theory. In reality, the value obtained by a standard instrument with high enough...[Details]
If you can receive the Asia 3S satellite, you can adjust the azimuth of the satellite antenna and generally you can receive it. The following is a method of adjusting satellite programs collected f...[Details]
Step 1: Install JRE and Eclipse For detailed steps, please refer to: http://blog.csdn.net/ex_net/article/details/7251664 Step 2: Install arm -linux-gcc and arm-linux-g++ (1) Copy arm-linux...[Details]
On January 20, Pony.ai announced the launch of its self-developed automotive-grade computing unit solution, equipped with NVIDIA DRIVE Orin™ (SoC). Through in-depth cooperation with NVIDIA, a milesto...[Details]
A silent battle has begun between the world's two largest mobile phone SoC giants. Recently, MediaTek released the Dimensity 5G open architecture for the first time, supporting OEMs to flexibly cust...[Details]
At present, driven by new theories and technologies such as mobile Internet, big data, and supercomputing and the needs of economic and social development, artificial intelligence is developing rap...[Details]
With the continuous innovation and development of science and technology and the ever-changing geopolitical environment, the development situation of the global semiconductor industry in recent years...[Details]
The steps of edge detection related algorithms are as follows:
1. Filtering: The edge detection algorithm is mainly based on the first and second order derivatives of the image intensity, but ...[Details]
keil4
method one:
First install KEIL4, then install KEIL3 to the same directory as MDK, skip the one that has been installed. Then open KEIL4 as an administrator, use KEIL4's registr...[Details]
This is the byte alignment keyword. It was not required when using the ADS compiler before, but it needs to be added when using the later Keil compiler (for example, when using the Zhou Ligong templat...[Details]
Friends in the power supply industry know that battery -powered inverters usually consist of two stages. The front-stage DC/DC circuit converts the battery voltage into a DC voltage of about 350V, an...[Details]
With the vision of "a robot for every person", UiPath, a leader in enterprise Robotic Process Automation (RPA) software, recently announced the launch of the industry's first end-to-end hyperautomati...[Details]
Ionizing radiation such as X-rays and gamma rays has been widely studied and applied in various fields such as medical imaging, non-destructive testing, and scientific research.
Ther...[Details]