Features .......................................................................................................................................................................................1
Ordering Information .....................................................................................................................................................................2
Dimensions and Patterns ― 3.2 x 2.5 mm .................................................................................................................................14
Dimensions and Patterns ― 5.0 x 3.2 mm .................................................................................................................................14
Dimensions and Patterns ― 7.0 x 5.0 mm .................................................................................................................................15
Additional Information .................................................................................................................................................................16
Revision History ..........................................................................................................................................................................17
Rev 1.06
Page 3 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Electrical Characteristics
Table 2. Electrical Characteristics – Common to LVPECL, LVDS and HCSL
All Min and Max limits in the Electrical Characteristics tables are specified over temperature and rated operating voltage with standard
output termination shown in the termination diagrams. Typical values are at 25°C and nominal supply voltage.
Parameter
Output Frequency Range
Frequency Stability
Symbol
f
F_stab
Min.
220.000001
-15
-25
-35
-50
Operating Temperature Range
T_use
-20
-40
-40
-40
Supply Voltage
Vdd
2.97
2.70
2.52
2.25
Pull Range
Upper Control Voltage
Lower Control Voltage
Control Voltage Input Impedance
Control Voltage Input Bandwidth
Pull Range Linearity
Frequency Change Polarity
Input Voltage High
Input Voltage Low
Input Pull-up Impedance
Duty Cycle
Start-up Time
OE Enable/Disable Time
PR
VC_U
VC_L
VC_z
V_c
Lin
–
VIH
VIL
Z_in
DC
T_start
T_oe
70%
–
–
45
–
–
Typ.
–
–
–
–
–
–
–
–
–
3.30
3.00
2.80
2.50
Max.
725
+15
+25
+35
+50
+70
+85
+95
+105
Supply Voltage
3.63
3.30
3.08
2.75
V
V
V
V
ppm
Vdd
Vdd
MΩ
kHz
%
–
–
30%
-
55
3.0
3.8
Vdd
Vdd
kΩ
%
ms
µs
Measured from the time Vdd reaches its rated minimum value.
f = 322.265625 MHz. Measured from the time OE pin reaches
rated VIH and VIL to the time clock pins reach 90% of swing
and high-Z. See
Figure 9
and
Figure 10
Pin 2, OE
Pin 2, OE
Pin 2, OE logic high or logic low
Contact SiTime
for other input bandwidth options
See the APR (Absolute Pull Range)
Table 11.
Contact SiTime
for custom pull range options
Voltage at which maximum frequency deviation is guaranteed
Voltage at which minimum frequency deviation is guaranteed
Unit
MHz
ppm
ppm
ppm
ppm
°C
°C
°C
°C
Extended Industrial
Extended Commercial
Industrial
Condition
Accurate to 6 decimal places
Inclusive of initial tolerance, operating temperature, rated
power supply voltage, load variations, and first year aging
at 25°C, with VIN voltage at Vdd/2.
±15
ppm is only guaranteed for pull range up to
±100
ppm.
Frequency Range
Frequency Stability
Temperature Range
Voltage Control Characteristics
±25, ±50, ±80, ±100, ±150, ±200,
±400, ±800, ±1600, ±3200
90%
–
–
–
–
–
–
10
10
–
Positive Slope
–
–
100
–
–
–
–
10%
–
–
1.0
Input Characteristics
Output Characteristics
Startup and OE Timing
Rev 1.06
Page 4 of 17
www.sitime.com
SiT3373
220 MHz to 725 MHz Ultra-low Jitter Differential VCXO
Table 3. Electrical Characteristics – LVPECL Specific
Parameter
Current Consumption
OE Disable Supply Current
Output Disable Leakage Current
Maximum Output Current
Output High Voltage
Output Low Voltage
Output Differential Voltage Swing
Rise/Fall Time
RMS Period Jitter
[4]
RMS Phase Jitter (random)
Symbol
Idd
I_OE
I_leak
I_driver
VOH
VOL
V_Swing
Tr, Tf
T_jitt
T_phj
–
0.220
0.270
ps
Min.
–
–
–
–
Vdd-1.15
Vdd-1.9
1.2
–
–
Typ.
–
–
0.15
–
–
–
1.6
225
1.0
Max.
97
63
–
32
Vdd-0.7
Vdd-1.5
2.0
290
1.6
Unit
mA
mA
A
mA
V
V
V
ps
ps
Condition
Excluding Load Termination Current, Vdd = 3.3 V or 2.5 V
OE = Low
OE = Low
Maximum average current drawn from OUT+ or OUT-
See
Figure 5
See
Figure 5
See
Figure 6
20% to 80%, see
Figure 6
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 156.25 or 322.265625 MHz, IEEE802.3-2005 10 GbE jitter
mask integration bandwidth = 1.875 MHz to 20 MHz,
all Vdd levels
f = 322.265625 MHz, Vdd = 3.3 V or 2.5 V
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -20 to 70°C and -40 to 85°C
f = 322.265625 MHz, Integration bandwidth = 12 kHz to 20 MHz,
all Vdd levels, includes spurs, pull range =
±100
ppm.
Temperature ranges -40 to 95°C and -40 to 105°C
f = 322.265625 MHz, IEEE802.3-2005 10 GbE jitter mask
integration bandwidth = 1.875 MHz to 20 MHz, all Vdd levels
Entrusted by the Department of Higher Education of the Ministry of Education and the Department of Personnel and Education of the Ministry of Industry and Information Technology, the National Undergra...
Shouldn't the PN532's IRQ pin generate an interrupt when a card is received? I'm using the serial port mode, but why is it that even though I set the IRQ pin to be enabled, it doesn't work? I can read...
[i=s] This post was last edited by shihuntaotie on 2019-1-9 21:39 [/i] [font=宋体][size=4] Read all sensor data of the kit according to the evaluation plan, and still use the online IDE for programming....
Attention, friends on the road, at work, and at home, Pingtou Ge's 100 sets of RISC-V ecological development board RVB2601 are worth 390 yuan. The New Year is coming. Submit your ideas now and you wil...
I was in a rush to deliver goods. I didn’t have time for the sample. I just made a small batch and poured copper. I made a mistake in a hurry. The ground terminal of the Kelvin sampling was poured. Wh...
Brief description of temperature measurement: The core function of DS18B20 is its direct digital temperature sensor. The accuracy of the temperature sensor is user-programmable 9, 10, 11 or 12 bits, ...[Details]
CS8516 is a 5V-15V wide voltage AB/D class switching chip mono audio power amplifier IC for radio applications. The efficiency of traditional Class AB audio amplifiers is generally around 55%. When...[Details]
The reasons for the leakage of lighting circuits are: first, the insulation of the wires or equipment is damaged by external force; second, the long-term operation of the circuit leads to aging and d...[Details]
OFweek Cup · OFweek 2023 China
Robot
Industry Annual Selection (abbreviated as OFweek Robot Awards 2023) is jointly organized by OFweek, China's high-tech industry portal, and its authorita...[Details]
On January 31, Motorola and Xiaomi demonstrated wireless charging technology this week. Regarding this new technology, some experts said that there are no technical difficulties in realizing wirele...[Details]
For many beginners, to deeply learn arm+linux, you need to consider from two directions, software and hardware. About in-depth learning of arm+linux, software learning: Software 1. Bootl...[Details]
Some friends who bought an oscilloscope may be curious when they see the refresh rate of the oscilloscope, wondering if they can measure it. Compared with the sampling rate, storage depth and other i...[Details]
CA8331 power quality analyzer product introduction: Designed for the energy conservation and harmonic management industries, the CA8331 power quality analyzer can provide a snapshot of key electrical...[Details]
There will be a long and dangerous "start-up period" when it is integrated into the existing road system Over the past four or five years, we’ve been hearing about the potential of self-driving cars ...[Details]
The maintenance of instruments and meters is an integral part of the electronics market. Only by relying on good testing technology can instrument and meter companies ensure that those unqualified pr...[Details]
Adobe reminded users this week that its Photoshop Sketch and Illustrator Draw apps will no longer be available for download on iOS and Android starting July 19. Adobe plans to stop supporting these a...[Details]
Combining "global experience and local resources" brings "more freedom and more possibilities" Stratasys, a provider of 3D printing and additive manufacturing solutions, will hold the "2019 Strat...[Details]
Interrupt handling:
Interrupt is the most important concept in embedded systems. Generally, a system uses either interrupt or polling for a device. Interrupt can effectively reduce the proce...[Details]
1 Introduction The auxiliary power system of electric locomotive is an important part of the locomotive. It is responsible for the power supply of various devices except the main circuit of the lo...[Details]
Electronics Design Contest
京公网安备 11010802033920号
EEWORLD
