* See Page 8 for additional developed frequencies.
Check with factory for availability of frequencies not listed.
Description
CTS Model 656P/L is a low cost, high performance PLL clock oscillator supporting differential LVPECL or LVDS
outputs. Employing the latest IC technology, M656P/L has excellent stability and low phase jitter performance.
Ordering Information
Model
656
Output
Type
P
Frequency Code
[MHz]
XXX or XXXX
Frequency
Stability
3
Temperature
Range
I
Supply
Voltage
3
Packaging
T
Code
P
L
E
V
Output
LVPECL - Pin 1 Enable
LVDS - Pin 1 Enable
LVPECL - Pin 2 Enable
LVDS - Pin 2 Enable
Code
6
5
4
3
Stability
±20ppm
2
±25ppm
3
±30ppm
±50ppm
Code
2
3
Voltage
+2.5Vdc
+3.3Vdc
Code
Frequency
Product Frequency Code
1
Notes:
1] Refer to document 016-1454-0, Frequency Code Tables.
3-digits for frequencies <100MHz, 4-digits for frequencies 100MHz or greater.
2] 6I Stability/Temperature combination not available.
3] Check factory availability when paired with 'I' temperature code.
Code Temp. Range
C
-20°C to +70°C
-40°C to +85°C
I
Packing
Code
1k pcs./reel
T
Not all performance combinations and frequencies may be available.
Contact your local CTS Representative or CTS Customer Service for availability.
This product is specified for use only in standard commercial applications. Supplier disclaims all express and implied warranties and liability in connection with any use of this
product in any non-commercial applications or in any application that may expose the product to conditions that are outside of the tolerances provided in its specification.
[i=s]This post was last edited by Jacktang on 2021-8-5 10:39[/i]SummaryThe quadcopter is a small-sized, relatively simple-to-control aircraft. The quadcopter designed in this project uses only a TI MS...
I bought a LAUNCHXL-CC1312R1 Rev: A development board online. The main chip is: XCC1312R1F3, and the development environment is: CCS920+simplelink_cc13x2_26x2_sdk_3_30_00_03. The current problem is:
1...
Regarding the selection of signal input mode of power amplifier. In professional audio engineering, we often encounter problems such as signal parallel connection and bridging. First of all, we must c...
I remember that I first came into contact with microcontrollers in 2002. At that time, the only microcontrollers I knew and used were AT98C8051 and AT98C8052. I had only heard of the 51-type microcont...
[i=s]This post was last edited by bobde163 on 2020-11-20 12:10[/i]Today I need to use Fluke F17B+ multimeter to measure uA current, which is different from the measurement of another Uni-T UT890C+. Th...
First of all, I declare that I am a rookie. Although I have worked for some years and have worked very hard, I am still a rookie. There is a cycle that makes me very distressed. When I first joined a ...
Electronics Design Contest
京公网安备 11010802033920号
EEWORLD
