Electromagnet overcurrent protection circuit
Source: InternetPublisher:toothache Keywords: Protection circuit electromagnet overcurrent protection BSP Updated: 2020/01/01
Once the armature of an AC electromagnet is blocked, the magnetic gap increases, the inductance is greatly reduced, and the coil current will reach 6 to
8 times the rated current. If not discovered in time, the electromagnet will be easily burned out. Therefore, in places with harsh operating environments or important occasions, it is necessary
to install protective devices for electromagnets.
Figure 6-61 is a simple electromagnet overcurrent protection circuit .
Resistor R can be selected according to the following formula:
R=UR/I. (n), power PI. In the formula R(W)
, UR - the voltage drop on the resistor R. When the rated operating voltage of the sensitive relay is 12V, UR can be 1.5-2V
. If the operating voltage is 24V, R can be 3-4V.
J. ——The rated current when the electromagnet is in the closed state. A.
- Design and selection of electric control valve system drive
- Current output characteristics of brushed motor driver chips. How to increase the peak drive current?
- Tutorial on making your own remote-controlled robotic arm
- Peripheral circuit of automotive motor controller power supply chip
- How to build a simple tachometer using an infrared reflectance sensor
- DIY an electromagnetic levitation device
- A small improvement on the ordinary refrigerator motor starting circuit
- Temperature control circuit design and analysis
- Design and analysis of a four-bit remote control component capable of remote reset
- Water supply reminder after water outage
- Self-defense anti-riot circuit
- Agricultural temperature control circuit
- Biogas concentration detection line
- Simple AGC circuit in transistor radio
- Common emitter-common base wideband amplifier circuit composed of F733 integrated amplifier
- color discrimination circuit
- Guest arrival signal recognition circuit
- Fault signal trip circuit
- Motorcycle flash light circuit
- Digital stopwatch display circuit