Transistor common emitter amplifier circuit b
Source: InternetPublisher:Lemontree Keywords: Transistor common emitter amplifier circuit bias circuit static operating point Updated: 2020/03/15
The circuit adopts a bias circuit that automatically stabilizes the static operating point and has good thermal stability. The triode
is of NPN type (Iceo is very small). Adjusting the potentiometer RP can change the static operating point .
Figure (a) uses a voltage-divided emitter bias circuit ;
Figure (b) uses the thermistor R. to compensate for changes in operating point.
Latest Basic Circuits Circuits
- How to identify common mode interference? Methods to eliminate common mode interference
- Principle set of zero-crossing detection circuit advantages and disadvantages
- What types of power field effect tubes are there? Selection criteria for power field effect tubes
- How do you calculate the value of capacitors in series? Why use capacitors in series?
- Analysis of three simple electronic dice circuits
- Using an Op Amp to Drive a Simple and Practical Power Amplifier
- Experiment and production of NE555 time base integrated circuit
- An example of proportional integral circuit diagram
- AD108 frequency multiplier capable of inputting asymmetric square wave
- Odd-frequency counter with symmetrical output waveform (μL9020)
Popular Circuits
- Improved connection method of triode switch circuit circuit diagram
- Composite piped
- Mixing circuit
- Simple sawtooth wave generator circuit
- Soft start regulated power supply circuit 4
- 20V, 500mA regulated power supply circuit
- One of the anti-theft alarm circuits with warning wires
- Flash signal light circuit 7
- Humidity control circuit using transistors
- Automatic water supply control circuit 2 for simultaneous monitoring of water tower and reservoir
京公网安备 11010802033920号