PLC input and output wiring a
Source: InternetPublisher:狂妄火龙果 Keywords: PLC wiring BSP diode Updated: 2021/10/30
Wiring of PLC input and output terminals
When the PLC input terminal or output terminal is connected with inductive components, freewheeling diodes (DC circuit)
or RC circuits (AC circuit) should be connected in parallel at both ends to suppress the overvoltage generated when the circuit is disconnected. The impact on PLC is as shown in the figure.
In the figure, the t resistor R can range from 51 to 12002, and the capacitor C can range from 0.1 to 0, 47yF.
- JDB-LQ-TQ/2 motor full voltage starting circuit
- Working principle of ZNB-S digital display intelligent motor protector control circuit
- Methods for Eliminating Noise of Brushed DC Motors
- Simple phase failure protection circuit composed of intermediate relay
- Add one more component to improve the phase failure protection function
- Motorcycle anti-theft device circuit design
- Vibration anti-theft alarm circuit
- Refrigerator Thermostat Replacement Device
- A gas stove igniter circuit
- Making of a Rotating Mousetrap
- Self-defense anti-riot circuit
- Chicken supplementary light to increase egg production rate circuit
- Soil water shortage prompt circuit
- DC ammeter
- Mixer built with analog multipliers
- Simple AGC circuit in transistor radio
- collector amplitude modulation circuit
- Series crystal oscillator
- Inductive feedback oscillator circuit
- Sine wave signal generator circuit